Search Results for test specimen

Fig. 10 Test specimen with an extensometer attached to measure specimen deformation. Courtesy of Epsilon Technology Corporation More

Fig. 14 Test specimen with an extensometer attached to measure specimen elongation. Courtesy of Epsilon Technology Corporation. Source: Ref 4 More

Fig. 4.4 Compression test specimen. (a) View of specimen, showing lubricated shallow grooves on the ends. (b) Shape of the specimen before and after the test More

Fig. 17 Boeing wedge test (ASTM D 3762). (a) Test specimen. (b) Typical crack propagation behavior at 49 °C (120 °F) and 100% relative humidity. a , distance from load point to initial crack tip; Δ a , growth during exposure. Source: Ref 4 More

Fig. 15.10 Welded pipe test specimen and typical test stand More

Fig. 3 Jominy end-quench hardenability test. (a) Standard end-quench test specimen, (b) specimen in a quenching jig.(c) Hardness plot and cooling rate as a function of distance from the quenched end More

Fig. 5.2 Test specimen for a block-on-ring test; F r is resistive force, F n is load More

Fig. 3-38 Effect of test specimen orientation and location on the tension test properties of a 150 lb (68 kg) wheel forging of water quenched and tempered AISI 1050 steel. Each bar on the chart represents maximum, minimum, and average values of three tests. ( 3 ) More

Fig. 3 Low-carbon cast steel test specimen emphasizing 45° shear aspect of tensile fracture of a ductile metal. Diagonal ridges are “Lüders lines” or “stretcher strains”; porosity in the steel shows many localized fractures. More

Fig. 18 Standard end-quench (Jominy) test specimen and method of quenching in quenching jig. Source: Ref 9 More

Figure 1-35 Fractograph of wedge test specimen of cast iron. The white areas indicate the presence of iron carbide, while the dark areas indicate that flake graphite is present. More

Fig. 9.8 Typical single-lap shear test specimen. Source: Ref 9.1 More

Fig. 8.18 Tear test specimen and representation of load-deformation curve from a tear test. A, area; M, moment; C, moment arm; I, moment of inertia More

Fig. D2.1 Growth curves for aluminum alloy 238.0-F, permanent mold. Test specimen: 1.125 diam × 12 in. rod More

Fig. A3.6 Tear test specimen, including positions in welded panels. Notch-tip radius ≤ 0.001 in. Refer to ASTM B 871. More

Fig. 5 The deformation of an elemental length, dx 0 , of a tensile test specimen of initial cross-sectional area, A 0 , by a stress wave. The displacement of the element is u ; the differential length of the element as a function of time is dx ; the forces acting on the faces More

Fig. 17 Test specimen with bonded resistance strain gages and a 25 mm (1 in.) gage length extensometer mounted on the reduced section More

Fig. 6 Sheet tensile test specimen More

Fig. 10 Plane-strain tensile test specimen. Source: Ref 33 More