1-20 of 11364 Search Results for

source

Sort by
Book Chapter

Series: ASM Technical Books
Publisher: ASM International
Published: 01 March 2002
DOI: 10.31399/asm.tb.stg2.t61280353
EISBN: 978-1-62708-267-9
... This appendix identifies producers, suppliers, and service providers experienced with superalloy materials and applications. It also identifies potential sources of engineering information and property data. superalloys data sources Some Superalloy Information/Product Sources...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 July 2009
DOI: 10.31399/asm.tb.bcp.t52230019
EISBN: 978-1-62708-298-3
... In ordinary rocks and soils, as well as in bituminous coals, concentrations of beryllium fall in the range of 0.1 to 3.0 ppm. The beryllium content of mineral oils is estimated at less than 100 μg/L and of natural waters at below 1 μg/L. None of these materials have had any value as commercial sources...
Book Chapter

Series: ASM Technical Books
Publisher: ASM International
Published: 01 March 2002
DOI: 10.31399/asm.tb.stg2.t61280365
EISBN: 978-1-62708-267-9
... E.F. , Ed., Superalloys: A Technical Guide , 1st ed. , ASM International , 1988 • Sims C.T. , Stoloff N.S. , and Hagel W.C. , Ed., Superalloys II , Wiley , 1987 • Donachie M.J. , Ed., Superalloys Source Book , American Society for Metals , 1984...
Series: ASM Technical Books
Publisher: ASM International
Published: 31 March 2024
DOI: 10.31399/asm.tb.gvar.t59360051
EISBN: 978-1-62708-435-2
... Abstract The cyclic nature of gearbox vibration lends itself well to the analysis in the frequency domain where the effects of a gear mesh, bearing defects, and other sources of vibration are effectively set apart, making it much easier to identify and correct the underlying causes of vibration...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 September 2008
DOI: 10.31399/asm.tb.fahtsc.t51130177
EISBN: 978-1-62708-284-6
... due to service-related causes, such as misalignment, poor lubrication, and overloading, which constitute the greatest source of all gear failures, as shown in Table 2 ( Ref 7 ). Heat treatment was the second most often cited cause for failure. However, it is often difficult to detect the root cause...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 July 2000
DOI: 10.31399/asm.tb.fec.t65940451
EISBN: 978-1-62708-302-7
... Abstract This appendix is a comprehensive collection of selected sources related to corrosion properties of materials and corrosion testing. corrosion properties corrosion testing Corrosion Properties of Materials Corrosion Properties of Materials • Corrosion , Vol 13...
Image
Published: 01 November 2019
Figure 29 Example of the two probe sweep for Drain to Source or Source to Drain for the middle of channel gate oxide damaged transistor exhibits minimal leakage current (low nA). The Source and Drain LDD junctions are intact, but the gate damage in the middle of the channel most likely causes More
Image