1-9 of 9 Search Results for

parison programming

Sort by
Series: ASM Technical Books
Publisher: ASM International
Published: 01 August 2013
DOI: 10.31399/asm.tb.ems.9781627082839
EISBN: 978-1-62708-283-9
Series: ASM Technical Books
Publisher: ASM International
Published: 01 February 2005
DOI: 10.31399/asm.tb.chffa.t51040083
EISBN: 978-1-62708-300-3
... in the flow stress equation, friction factor, and anisotropy coefficients of a material are usually obtained from the appropriate tests. The results of process simulation are extremely sensitive to the accuracy of flow stress and interface friction that are input to FEM programs. Therefore, it is essential...
Book Chapter

Series: ASM Technical Books
Publisher: ASM International
Published: 01 March 2006
DOI: 10.31399/asm.tb.fdsm.t69870179
EISBN: 978-1-62708-344-7
... adequately accurate solutions for specific geometries. The method is well known today, and many computer programs exist for implementing the calculations, even by those who may not be thoroughly familiar with the fundamentals. Basically, the body to be analyzed is divided into a number of finite-sized...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 November 2007
DOI: 10.31399/asm.tb.htcma.t52080379
EISBN: 978-1-62708-304-1
... temperature, the specimen was then subjected to a simulated, programmed postweld heat treatment temperature and held at constant temperature and load until failure ( Ref 22 ). The rupture ductility of HCM2S was found to be significantly lower than that of 2.25Cr-1Mo, as shown in Fig. 14.27 ( Ref 22 ). HCM2S...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 March 2006
DOI: 10.31399/asm.tb.fdsm.9781627083447
EISBN: 978-1-62708-344-7
Series: ASM Technical Books
Publisher: ASM International
Published: 01 February 2005
DOI: 10.31399/asm.tb.chffa.t51040277
EISBN: 978-1-62708-300-3
... another in both the x - and y -directions. In addition, the table that holds the workpiece can move in the same directions. Movement of the guides and worktable is controlled by numerical-controlled programming. In forging, WEDM is mainly used for manufacturing trimming dies. 21.5.3 Hobbing...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 November 2007
DOI: 10.31399/asm.tb.htcma.9781627083041
EISBN: 978-1-62708-304-1
Series: ASM Technical Books
Publisher: ASM International
Published: 01 December 2003
DOI: 10.31399/asm.tb.cfap.t69780028
EISBN: 978-1-62708-281-5
Series: ASM Technical Books
Publisher: ASM International
Published: 01 February 2005
DOI: 10.31399/asm.tb.chffa.9781627083003
EISBN: 978-1-62708-300-3