1-5 of 5 Search Results for

Vending machines

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Book Chapter

Series: ASM Technical Books
Publisher: ASM International
Published: 01 December 2001
DOI: 10.31399/asm.tb.aub.t61170520
EISBN: 978-1-62708-297-6
... machines (photocopiers, facsimile machines, cash registers, and typewriters), and in such items as recording machines, projectors, vending machines, cameras, gasoline pumps, many hand tools, and machinery such as larger drill presses and lathes. The higher aluminum content alloys (the ZA alloys described...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 November 2011
DOI: 10.31399/asm.tb.jub.t53290137
EISBN: 978-1-62708-306-5
... of properties for acceptance by the general public and for use in automatic vending machines. Copper clad with copper-nickel was found to meet these requirements. Although stringent in its requirement for surface preparation, the cladding process is relatively simple ( Fig. 6.8 ). Clad strips are produced...
Series: ASM Technical Books
Publisher: ASM International
Published: 30 June 2023
DOI: 10.31399/asm.tb.atia.t59340453
EISBN: 978-1-62708-427-7
.... Anheuser-Busch had a recycling company because they realized the cost of aluminum sheet was so strategically important for their bottom line. Reynolds, a large producer of both can sheet and finished cans, built reverse vending machines for supermarkets and used mobile trailers to collect used cans...
Series: ASM Technical Books
Publisher: ASM International
Published: 01 December 2001
DOI: 10.31399/asm.tb.aub.9781627082976
EISBN: 978-1-62708-297-6
Series: ASM Technical Books
Publisher: ASM International
Published: 01 December 2003
DOI: 10.31399/asm.tb.cfap.t69780003
EISBN: 978-1-62708-281-5
... values) Metals Ceramics Polymers Density, g/cm 3 2–22 (average ~8) 2–19 (average ~4) 1–2 Melting points Low (Ga = 29.78 °C, or 85.6 °F) to high (W = 3410 °C, or 6170 °F) High (up to 4000 °C, or 7230 °F) Low Hardness Medium High Low Machinability Good Poor Good Tensile...