Skip Nav Destination
ASM Technical Books
Tool Steels (Fifth Edition)
ASM International
ISBN electronic:
978-1-62708-358-4
Publication date:
1998
Book Chapter
Chapter 17: Troubleshooting: Manufacturing and Performance Problems
-
Published:1998
Page range:
325 - 343
Abstract
This chapter presents an overview of some of the major causes of tool and die failures. The chapter describes fracture and fracture toughness of tool steels, and the influence of factors such as steel quality and primary processing, mechanical design, heat treatment, grinding and finishing, and distortion and dimensional change.
You do not currently have access to this chapter.
Citation
Troubleshooting: Manufacturing and Performance Problems, Tool Steels, 5th ed., By George Roberts, George Krauss, Richard Kennedy, ASM International, 1998, p 325–343, https://doi.org/10.31399/asm.tb.ts5.t65900325
Download citation file:
Related Book Content
Why Tools and Dies Fail
Failure Analysis and Prevention
Influence of Work Material Properties on Finishing Methods
Surface Engineering
Control of Distortion in Tool Steels
Heat Treating of Irons and Steels
Distortion in Tool Steels
Heat Treating of Irons and Steels
Selection, Application, and Disposal of Finishing Fluids
Surface Engineering
Heat Treatment of Malleable and Compacted-Graphite Irons
Heat Treating of Irons and Steels
Finishing, Heat Treatment and Inspection
Steel Castings Handbook (Sixth Edition)
Failure Analysis in Tool Steels
Failure Analysis of Heat Treated Steel Components
Distortion Engineering
Steel Heat Treating Technologies