Skip Nav Destination
ASM Technical Books
Tool Steels (Fifth Edition)Available to Purchase
ASM International
ISBN electronic:
978-1-62708-358-4
Publication date:
1998
Book Chapter
Chapter 3: Manufacture of Tool Steels Available to Purchase
-
Published:1998
Page range:
29 - 43
Abstract
This chapter describes some of the more typical manufacturing practices, along with their benefits and limitations. The manufacturing practices covered include primary melting, electroslag remelting, rolling, hot and cold drawing, and continuous casting. The chapter discusses the advance and application of powder metallurgy. A few of the more recently introduced processes that hold considerable promise for producing tool steels or finished tools at a lower cost or with improved quality also are reviewed.
You do not currently have access to this chapter.
Citation
Manufacture of Tool Steels, Tool Steels, 5th ed., By George Roberts, George Krauss, Richard Kennedy, ASM International, 1998, p 29–43, https://doi.org/10.31399/asm.tb.ts5.t65900029
Download citation file:
Related Book Content
Copper Wire and Cable
Metals Handbook Desk Edition (2nd Edition)
Computational Analysis of the Vacuum Arc Remelting (VAR) and Electroslag Remelting (ESR) Processes
Metals Process Simulation
Forming Cracks on Stainless Steel Wire
ASM Failure Analysis Case Histories: Processing Errors and Defects
Electroslag Remelting
Casting
Primary Mill Fabrication
Metals Fabrication Understanding the Basics
Classification and Selection of Tool Steels
Tool Steels (Fifth Edition)
Cold-Finished Steel Bars
Properties and Selection: Irons, Steels, and High-Performance Alloys
Aluminum Alloy Ingot Casting and Continuous Processes
Aluminum Science and Technology
Glossary: Bulk Forming
Metalworking: Bulk Forming