The powder metallurgy (P/M) process has been applied to a high strength turbine disk alloy. It is known that P/M alloys show characteristic microstructures such as prior powder boundaries (PPB) compared to microstructures of conventional cast and wrought (CW) alloys. High temperature tensile tests were conducted on CW and P/M processed alloy720Li in order to reveal the effect of temperature and strain rate on deformation behavior and to demonstrate the effect of microstructure derived from P/M process on deformability. The fracture mode of the P/M material changed from grain interior fracture to fracture around large PPB with an increment of strain rate. In addition, samples ruptured at higher temperature showed grain boundary fracture regardless of strain rate. On the other hand, the CW material showed good deformability with chisel point fracture in the entire temperature and strain rate condition range. In the P/M material, melting of grain boundaries occurred at super solvus temperature conditions. Large PPB acts as nucleation site of voids at higher strain rate conditions. Precipitation strengthening by γ’ phase degrades deformability at sub solvus temperature conditions. However, deformability near the solvus temperature and low strain rate condition in as HIPed P/M material increased with fine grain size distribution in spite of the presence of large grains resulting from PPB.

The effects of pre-strain on creep properties of Alloy 740 have been investigated. Tensile strain was 7.5% and introduced by room temperature tensile test. Creep tests were conducted under 750 degree C, 275-350MPa. Creep rupture life of pre-strained sample decreased by half compared with as-heat treated sample. Creep behaviors of both samples were almost similar in primary creep stage, but onset of creep rate acceleration of pre-strained sample was faster than those of as-heat treated sample. As a result, minimum creep rate of pre-strained sample were two times larger than that of as-heat treated sample. From the observation of ruptured specimen, pre-strained sample had much more sub cracks than as-heat treated sample. On the other hand, microstructure of both samples was also different. There were MC precipitates on grain boundary in both ruptured specimens, but both size and number of MC precipitates were larger in pre-strained sample although creep life of pre-strained sample was shorter than that of as-heat treated sample. In this paper, the difference of creep behavior will be discussed in terms of both the microstructural change and mechanical damage.