The aim of this work is to optimize molybdenum disilicide coatings for high-temperature oxidation protection of metallic surfaces. Agglomerated and sintered MoSi2 powder was deposited on test substrates by atmospheric plasma spraying. The powders and coatings were characterized by means of optical and scanning electron microscopy. Various tests were carried out to determine the influence of powder size and spray parameters on coating porosity, hardness, and adhesive pull strength.

Thermally sprayed cermet powder coatings as well as bulk cermet materials sintered of carbide/metal powder blends are widely used in applications with severe abrasive wear conditions. A cost-saving alternative can be provided by using iron-based melt-atomised hard alloy powder feedstocks. Among them, commercial alloys containing high amounts of vanadium and carbon obtain outstanding wear resistance due to their high volume fraction of finely dispersed, hard vanadium carbides. However, their performance is still exceeded by cemented carbides. A further improvement of the wear properties of hard alloys basically can be attained by increasing their carbide content, concurrently considering the limitations of the melting and atomisation process regarding the melting temperature. A possible solution can be provided by alloying the basic system Fe-V-C with an additional strong carbide former like niobium. Subject of this work is the comparing investigation of the technologically important melting equilibria in the systems Fe-V-C and Fe-V-C-Nb.

The thermal spray application of inert gas atomised iron based powders for combined wear and corrosion protection prospectively offers important economical advantages compared to the well-established cermet coatings due to their lower price. Recent studies revealed basic knowledge about the thermal spray processing of these materials. For protecting the substrate from corrosive media, coatings have to be dense and impermeable to fluids. Especially poor bonding, occurring between partially melted or unmelted spray particles, leads to open porosity. Hence a certain degree of melting of particles is required. The GTV K2 spray gun allows the use of different nozzles to vary process temperature and velocity in a wide range. This paper shows the influence of applicated nozzles and process conditions on coating characteristics. Powder and coating characterisation is carried out by means of optical microscopy, digital image analysis, SEM and XRD. Additionally, some results regarding microhardness and wear behaviour are given.