The excellent corrosion resistance and biocompatibility of titanium make of it the material to choose for biomedical applications. Cold spraying, as a new coating technique, can be used to deposit protective Ti coatings onto less performing materials such as stainless steel and Co-Cr alloys, commonly used for biomedical implants. In addition, Cold Spray has the advantage, in comparison with conventional thermal spray techniques, to permit the deposition of oxygen-sensitive materials. In this study, Cold Sprayed Ti coatings were prepared on Co-Cr alloy substrates by using different spray process conditions. The microstructure of coatings was observed by SEM and the inner porosity was estimated by image analysis. Oxygen and nitrogen contents were investigated on a set of free standing deposits obtained using different process parameters. In the same way, the roughness and microhardness of deposits, such as the adhesion strength with the substrate, were measured. Finally, the corrosion performance of the coatings was evaluated by mean of open circuit potential measurement (OCP) and potentiodynamic polarizations scans. The electrochemical response was therefore discussed and compared to the corrosion behaviour of the Co-Cr alloy substrate and the bulk Titanium.

Titanium and titanium alloy coatings have high potential for applications in several industrial fields such as aerospace, bio-medical and chemical industries. Its eligibility for each single application depends on physical, chemical and mechanical properties. Cold spray as a deposition technique for titanium coating is growing because there is no need for vacuum or protective atmospheres. The properties of cold spray titanium coatings can be tailored by controlling and optimizing the process parameters. In this study the effect of the gas pressure and temperature on the deposition process and the coatings properties were examined. Cold spray CP-titanium coatings were produced using nitrogen as propellant gas at different gas pressures (from 2.0 MPa to 3.5 MPa) and temperatures (from 400°C to 800°C). Morphology and the microstructure of the CP titanium powder and coatings were studied by scanning electron microscope (SEM) and light optical microscope (LOM). Micro-hardness measurements and oxygen and nitrogen contents of titanium powder and the coatings were performed. As a final step, residual stress analysis of deposits were measured by means of X-ray diffraction.

During cold spraying, small particles are propelled to supersonic speeds and adhere to the substrate on impact, forming a strong bond. This work examines the effect of process gas temperature on cold spray coatings produced from commercially pure (CP) titanium powders. Nitrogen gases at 400, 600, and 800 °C were used as the propellant and nitrogen and oxygen content in the titanium coating was examined. The findings suggest that at high gas temperatures, the oxygen and nitrogen in the commercially pure titanium deposits increases at the particle boundaries.

The application of ceramic die coatings on tool steel dies in the casting industry has been common practice for many decades. The main function of these coatings is to provide a thermal barrier to prevent premature solidification during die filling, and protect the tool steel die from the effects of molten metal during casting with aluminium alloys. Although these coatings provide good insulation they are fragile and require on-going in-situ maintenance by machine operators. These inherent poor qualities makes the die casting process difficult to control and to maintain cast product quality because the solidification pattern and porosity changes and leads to increased cast product rejects. To overcome the limitations a novel die coat has been developed for the light metal casting industry utilising thermal spraying of co-deposited MgZrO 2 and polymer particles. The coating is then thermally treated to reveal a fine network of porosity that has been found by heat transfer coefficient testing to enhance the thermal properties and overall coating durability during casting. This paper describes the porosity control system which was used to tailor the heat transfer coefficient of co-deposited MgZrO 2 and polymer coatings and compare them with the heat transfer coefficient of commercially available die coats. The inherent porosity and the overall coating thickness were found to have a large effect on the heat transfer coefficient. Results of industrial trials are also presented and show that co-deposited MgZrO 2 and polymer coatings provide considerable improvements to productivity and enhanced coating life in Gravity and Low Pressure Die casting of aluminium alloys.