Spray process of hydroxyapatite was optimized by an advanced statistical planning of experiments. Full factorial design of 24 experiments was used to find effects of four principal plasma spray parameters, i.e. electric power, plasma forming gas composition, carrier gas flow rate and distance of spraying onto microstructure of hydroxyapatite (HA) coatings and powders. The Nemrod software has been applied to obtain the mathematical model of influence of these parameters onto experimental response. The chosen response was the volume fraction of HA crystal phase with regard to its decomposition phases. Two most important factors influencing this response are electric power supplied to torch and art of powder injection. The crystal phase content of powders and coatings was determined using X–ray diffraction (XRD) quantitative analysis. The morphologies of coatings surfaces, cross sections were characterized using scanning electron microscope (SEM).

The paper aims at the development of coating having a gradient of crystal grain size. Thick, inner layer was plasma sprayed using coarse TiO 2 powder. This layer has the thickness ranging from 30 to 50 µm. Thin, outer layer of thickness smaller than 10 µm, was plasma sprayed using different aqueous suspensions of fine powders of TiO 2 . The morphology of coarse and fine powders was characterized using scanning electron microscope (SEM) X-ray diffraction (XRD). Electronic emission was tested using home made setup. X-ray diffraction enabled to find out an interesting result which is formation of a mixture of rutile and anatase in suspension sprayed coatings. This was also confirmed by Raman spectroscopy investigations. The technology of suspensions plasma spraying was optimized to obtain homogeneous and dense deposits. The sizes were in the range of tenth to one hundred nanometers in initial powders and get clearly smaller in the coatings sprayed using coarse powder but remained quite similar in suspension sprayed films. X-ray photoelectric spectroscopy (XPS) was used to analyze quantitatively TiO 2 powders and coatings. Electronic emission was correlated with phase composition of the coating and their grain size.