The thermal cycle test of Al 2 O 3 sprayed 1%Cr-0.5%Mo steel and 18%Cr-8%Ni steel was performed, and the failure type of thermally sprayed coating on both steels was compared. The results obtained are follows. (1)The thermal cycle fatigue life of thermal sprayed 1%Cr- 0.5%Mo steel was shorter than that of thermal sprayed 18%Cr-8%Ni steel. (2)In the case of thermally sprayed 18%Cr-8%Ni steel that is difficult to oxidize at high temperature, during thermal cycle, a tensile stress occurs in a sprayed coating and a compressive stress occurs in a substrate. Thus the thermal strain occurs at the interface of sprayed coating and substrate. The sprayed coating delaminates when the thermal cycles reach the limit value. (3)In the case of thermal sprayed 1%Cr-0.5%Mo steel that is easy to oxidize at high temperature, during thermally cycle, dense oxide film forms at the interface between the sprayed coating and substrate, and adhesive strength in the interface becomes low. Thus the sprayed coating delaminates under the lower thermal strain.

The pin test and stress analysis by FEM were performed for erosion-resistant thermal sprayed coatings, and characteristic of interfacial strength between sprayed coating and substrate was assessed. As a result, the (Kcr) was not affected with specimen size and uniformly converges in spite of the eccentricity of pin.

The blast erosion-resistance properties of HVOF thermal spray Cr 3 C 2 type coating system and aluminized material were examined to improve erosion-resistance of turbine housings of compressors used in turbochargers for marine diesel engines. As a result, the erosion life of aluminized material is as same as that of the substrate, on the other hand the erosion life of thermal sprayed coating is ten times of that of the substrate. Therefore, erosion life of turbine housing can be extended by the surface treatment procedure. This technology is applicable to actual products.

In cold spray, feedstock powders are accelerated by supersonic jet with solid phase and deposited onto substrate. Compare with the conventional thermal spray, the coatings have low porosity without oxidation and decomposition. This study examines the effect of the powder compressive strength of each particle on coating deposition characteristics using two types of Ni powders, manufactured in a different process, in cold spray. The result indicated that heat treatment reduced the powder compressive strength, and the decrease of the powder compressive strength was related to the increase of bond strength of particles and deposition efficiency. In addition, it was shown that the powder compressive strength has an influence of deposition mechanism.