Although there are many advanced technologies and techniques for silicon diagnostics, effective failure analysis to root cause is getting increasingly challenging, as very often the electrical failure analysis data would point to a symptom that is the result of the defect rather than the actual location of the defect. Therefore, a combination of multiple techniques is often employed so that sensitivity of "the cause of the problem" can be observed. This work compiles a successful analysis with the aid of continuous wave laser voltage probing and soft defect localization techniques and presents three cases that are voltage-sensitive fails. The first case is a 28 nm device which failed at-speed scan. The second case is a 28 nm device failing RAM register BIST with high Vmin and the third case is a scan shift failure in a less than 28nm device.

A variety of EFA techniques have been deployed to improve scan chain failure isolation. In contrast to other laser techniques, modulation mapping (MM) does not require electrically perturbing of the device. Beginning with a review of MM and continuous-wave (CW) probing as well as shift debug using MM, this paper presents three case studies involving scan chains with subtle resistive and leakage failure mechanisms, including transition, bridge, and slow-to-rise/fall failures, using a combination of these techniques. Combining modulation mapping with laser probing has proven to be a very effective and efficient methodology for isolating shift defects, even challenging timing-related shift defects. So far, every device submitted for physical failure analysis using this workflow has led to successful root cause identification. The techniques are sufficiently non-invasive and straightforward that they can be successfully applied at wafer level for volume, yield-oriented EFA.

Laser Voltage Imaging (LVI) is a new application developed from Laser Voltage Probing (LVP). Most LVP applications have focused on design debug or design characterization, and are seldom used for global functional failure analysis. LVI enables the failure analysis engineer to utilize laser probing techniques in the failure analysis realm. In this paper, we present LVI as an emerging FA technique. We will discuss setting up an LVI acquisition and present its current challenges. Finally, we will present an LVI application in the form of a case study.

Yield on specific designs often falls far short of predicted yield, especially at new technology nodes. Product-specific yield ramp is particularly challenging because the defects are, by definition, specific to the design, and often require some degree of design knowledge to isolate the failure. Despite the wide variety of advanced electrical failure analysis (EFA) techniques available today, they are not routinely applied during yield ramp. EFA techniques typically require a significant amount of test pattern customization, fixturing modification, or design knowledge. Unless the problem is critical, there is usually not time to apply advanced EFA techniques during yield ramp, despite the potential of EFA to provide valuable defect insight. We present a volume-oriented workflow integrating a limited set of electrical failure analysis (EFA) techniques. We believe this workflow will provide significant benefit by improving defect localization and identification beyond what is available using test-based techniques.