Extension of the service life for high temperature structural alloy RA602CA is the goal for the project described in this paper. The performance of alloy RA602CA and aluminized RA602CA in a gas carburization furnaces were studied for periods up to two years. Aluminizing treatments (widely used in aerospace industry, especially in turbine blade applications) were also studied in this project. Carbon has very low solubility in alumina, so aluminizing could be a good method for protecting RA602CA alloys. Microstructural development during the carburizing process is presented, and the degradation of chromium oxide as well as alumina oxides is identified. The weight gain of RA602CA compared to similar alloys is discussed.

Gas quenching is drawing increasing attention within the heat treat industry. The heat transfer coefficient (HTC) for gas quenching can reach 2000 when using high pressure and high velocity nitrogen, helium, or mixtures of these gases. The HTC in water quenching is between 3000 and 4000. The lower HTC of gas quenching may result in workpieces with less distortion and residual stress after quenching. Compared to water, polymer, and oil quenching, gas quenching is environmentally friendly, and the surface of the part is clean after quenching.

A finite element (FE) method was used to determine the important heat treating process parameters that impact the residual stress and distortion in steel. The FE model combines a commercially available heat treatment software DANTE to the finite element analysis software ABAQUS. A thermomechanical FE model was developed to model the evolution of microstructure, the volumetric changes associated with the kinetics of martensitic phase transformation and the formation and distribution of residual stress during quenching of steel. Alternative quenching parameters such as different steel grades, quenching orientation, immersion speed, quenching agent, quenching temperature, austenitizing temperature and part geometry were ranked based on their impact. The main purpose of this paper is to provide processing guidelines to control residual stress and distortion.

To experimentally investigate the effect of tempering temperature and time on the structure and composition of martensite, AISI 52100 was austenized at 1000°C for 40 minutes and quenched in agitated water at 21°C. The as-quenched steel contained body-centered tetragonal (BCT) martensite with 22% retained austenite. These samples were tempered at 100°C, 200°C, and 300°C with different holding times and then were characterized by x-ray diffraction (XRD) to determine the effect on the structure of the martensite. It was found that the content of retained austenite did not change after tempering at 100°C. Retained austenite decomposed after tempering for 40 minutes at 300°C. The changes in crystal structures and lattice parameters for tempered martensite with different holding times and temperatures were measured. The effect of sample preparation on retained austenite and the structure of martensite and tempered martensite was evaluated. An effective technique for carbide extraction and collection in steel is introduced.