In order to clarify the bonding mechanism and to control the quality of cold-sprayed coatings, it is necessary to accurately measure the in-flight velocity and impact velocity of a projectile. In this study, the in-flight velocity of an aluminum alloy (A2017) 1 mm sphere shot from a small two-stage light gas gun was measured as being 1 km/s using a laser-cut velocity measurement technique. So as to estimate the impact velocity of the projectile, the projectile was caused to impact targets made of aluminum (A1050), copper (C1012), mild steel (SPCC), and stainless steel (SUS304). After the impact tests, the impact crater shapes of the targets was measured using scanning electron microscopy(SEM), energy dispersive X-ray spectroscopy (EDS), and laser microscopy. The impact velocity of a projectile was estimated from obtained crater depth of the targets. In addition, microstructures of the interface between projectile and target were analyzed by EDS, electron backscattered diffraction (EBSD) and transmission electron microscopy (TEM).

In this investigation, particle image velocimetry (PIV) and direct imaging are used to measure particle velocities during cold spraying. Four feedstock powders were sprayed, including Ni, WC-Co, carbonyl Fe, and Cr steel. Multiple exposures at 500 ns intervals were used to measure in-flight particle velocities via direct imaging with a high shutter speed camera. Velocimetry measurements were made with a double-pulse laser and a high-resolution camera. With the minimum frame straddling time set to 100 ns, a maximum particle velocity of 1052 m/s was measured.

In this study, particle image velocimetry (PIV) is used to measure WC particle velocity during HVAF spraying. Measured velocities are compared with calculated velocities obtained using open source CFD software. Numerical simulation is also used to investigate particle temperatures. With the HVAF gun used, maximum particle velocity is reached around 18 mm from the nozzle exit with a corresponding gas temperature of 1400 K.