In this paper we will demonstrate new approaches for failure analysis of memory devices with multiple stacked dies and TSV interconnects. Therefore, TSV specific failure modes are studied on daisy chain test samples. Two analysis flows for defect localization implementing Electron Beam Induced Current (EBAC) imaging and Lock-in-Thermography (LIT) as well as adapted Focused Ion Beam (FIB) preparation and defect characterization by electron microscopy will be discussed. The most challenging failure mode is an electrical short at the TSV sidewall isolation with sub-micrometer dimensions. It is shown that the leakage path to a certain TSV within the stack can firstly be located by applying LIT to a metallographic cross section and secondly pinpointing by FIB/SEM cross-sectioning. In order to evaluate the potential of non-destructive determination of the lateral defect position, as well as the defect depth from only one LIT measurement, 2D thermal simulations of TSV stacks with artificial leakages are performed calculating the phase shift values per die level.

Lock-in Thermography in combination with spectral phase shift analysis provides a capability for non-destructive 3D localization of resistive defects in packaged and multi stacked die devices. In this paper a novel post processing approach will be presented allowing a significant reduction of measurement time by factor >5 in comparison to the standard measurement routine. The feasibility of the approach is demonstrated on a specific test specimen made from ideal homogenous and opaque material and furthermore on a packaged hall sensor device. Within the case studies the results of multiple single LIT measurements were compared with the new multi harmonics data analysis approach.

In this paper different sample preparation strategies for fast and efficient failure analysis of 3D devices are reviewed and further explored. It will be shown that a combined workflow using laser ablation and plasma FIB milling provides best flexibility to cover most of the FA use cases. Laser ablation guarantees fast, coarse material removal and the subsequent plasma FIB milling provides fast removal of any damage or imperfections induced by the laser ablation, precise navigation to the region of interest, a high quality surface finish allowing direct SEM imaging and analytics such as EBSD and, if required the preparation of a thin lamella for TEM analysis.