Contact resistance from wafer acceptance test (WAT) data is one of the critical parameter to significantly affect fabrication process. While WAT data shows open/short fail, high resistance fail and leakage fail in contact chain structure, the first job in failure analysis (FA) field is to localize failure site. For example, High resistance failure and leakage failure sites can be localized by Infrared Ray Optical Beam Induced Resistance Change (IR-OBIRCH) detection. Most of open failure modes could be isolated by front side passive voltage contrast (PVC) technique. However, there is still a limitation to this technique while contacts are still connected to substrate in metal-1/contact/active chain structure. Active Voltage Contrast (AVC) [1, 2] is a good method to overcome this problem, but the major concern is how to mark the failure location in SEM based probing system. In this paper, we provide a novel backside passive voltage contrast method to improve the failure analysis technique. By thinning down silicon substrate to the active area, a new contact chain from active area is created. Therefore, novel backside PVC is applied to locate the failed site.

The oxide-nitride-oxide (ONO) is one of the critical layers in the deep trench (DT) capacitor of the modern DRAM structure. This paper highlights a ONO inspection methodology, which used the silicon wet etching to enhance the ONO leakage point. First, a hole was milled nearby the leakage ONO, which was localized by using focused ion beam (FIB). Then, silicon was removed by an etching solution from the opening. When the poly of DT is etched through the ONO weak point, the leakage site will be enhanced. With the silicon wet etching enhancement, the ONO leakage point is easy to be observed by X-S FIB inspection. The real ONO leakage point is useful information for the root cause finding and the process improvement.

A dual beam FIB (Focused Ion Beam) system which provides the ion beam (i-beam) and electron beam (e-beam) function are widely used in semiconductor manufacture for construction analysis and failure cause identification. Although FIB is useful for defect or structure inspection, sometimes, it is still difficult to diagnose the root cause via FIB e-beam image due to resolution limitation especially in products using nano meter scale processes. This restriction will deeply impact the FA analysts for worst site or real failure site judgment. The insufficient e-beam resolution can be overcome by advanced TEM (Transmission Electron Microscope) technology, but how can we know if this suspected failure site is a real killer or not when looking at the insufficient e-beam images inside a dual beam tool? Therefore, a novel technique of device measurement by using C-AFM (Conductive Atomic Force Microscope) or Nano-Probing system after cross-sectional (X-S) FIB inspection has been developed based on this requirement. This newly developed technology provides a good chance for the FA analysts to have a device characteristic study before TEM sample preparation. If there is any device characteristic shift by electrical measurement, the following TEM image should show a solid process abnormality with very high confidence. Oppositely, if no device characteristic shift can be measured, FIB milling is suggested to find the real fail site instead of trying TEM inspection directly.