This article describes the electrical and physical analysis of gate leakage in nanometer transistors using conducting atomic force microscopy (C-AFM), nano-probing, transmission electron microscopy (TEM), and chemical decoration on simulated overstressed devices. A failure analysis case study involving a soft single bit failure is detailed. Following the nano-probing analysis, TEM cross sectioning of this failing device was performed. A voltage bias was applied to exaggerate the gate leakage site. Following this deliberate voltage overstress, a solution of boiling 10%wt KOH was used to etch decorate the gate leakage site followed by SEM inspection. Different transistor leakage behaviors can be identified with nano-probing measurements and then compared with simulation data for increased confidence in the failure analysis result. Nano-probing can be used to apply voltage stress on a transistor or a leakage path to worsen the weak point and then observe the leakage site easier.

In general failure analysis cases, a less invasive fault isolation approach can be utilized to resolve a visual root cause defect. In the case of nano technology, visual defects are not readily resolved, due to an increase in nonvisible defects. The nonvisible defects result in a lower success rate since conventional FA methods/tools are not efficient in identifying the failure root cause. For the advanced nanometer process, this phenomenon is becoming more common; therefore the utilization of advanced techniques are required to get more evidence to resolve the failure mechanism. The use of nanoprobe technology enables advanced device characterization in order to obtain more clues to the possible failure mechanism before utilizing the traditional physical failure analysis techniques.