The new Triplex-burner was used to develop 7 wt% Y 2 O 3 stabilised ZrO 2 thermal barrier coatings and to optimise the process parameters with respect to reproducibility. The investigations were focused on spray efficiency and coating porosity. Porosity levels and porosity distribution were measured with mercury intrusion, which turned out to be a very reliable characterisation technique. High reproducibility could be achieved in particular for low argon fluxes: the deviation of the porosity levels was below about 4%. Paper text in German.

Superalloy samples were coated with thermal barrier coatings (TBC). This TBC-system consisted of two layers. The first layer was a vacuum-plasma sprayed, corrosion resistant layer (MCrAlY) which also acted as a bond coat. The ceramic top layer was atmospheric-plasma sprayed Y2O 3 -stabilized ZrO 2 . In order to produce different microstructures, the plasma-spraying parameters for the production of the ceramic coatings were varied. The different ceramic coatings were characterized in terms of porosity and mean elastic modulus. The porosity distribution was also investigated due to its influence on the measured elastic modulus. To record the changes of the plasma sprayed Zirconia due to sintering, the mean elastic modulus of selected coatings was measured as a function of annealing time. One series of TBC-coated specimens was cyclically oxidized at a maximum temperature of 1100°C. After 500 h of thermal cycling, creep within the MCrAlY-bond coat led to a coating failure at both the internal beveled edge and free edge around the specimen. A finite element analysis study of the cyclic oxidation experiment was performed to gain insight into the stress redistributions within the bond coat as a function of time. During the initial temperature increase, critical tensile normal stresses developed above the MCrAlY-Zirconia interface at the free edge. However, these normal stresses became compressive for all following cooling cycles. On the other hand, large tensile normal stresses developed above the MCrAlY-Zirconia interface at the beveled edge during all the cooling cycles. Therefore, high normal stresses responsible for debonding were present within the ceramic coating during all cooling cycles with the most critical stresses occurring at the free edge during the first cooling cycle and near the beveled edge for all the following cooling cycles.