Thermal spray processes benefit from workpiece cooling to prevent overheating of the substrate and to retain metallurgical properties (e.g., temper). Cold-gas “plume quenching” is a plume-targeting cooling technique, where an argon curtain is directed laterally above the substrate surface to re-direct high temperature gases without impacting particle motion. However, there has been little investigation of its effect on the molten particles and the resulting coating properties. This study examined high- and medium- density tantalum and nickel coatings, fabricated by Controlled Atmosphere Plasma Spray with and without plume quenching on aluminum and titanium substrates. To compare the effect of plume quenching, the deposition efficiency was calculated through coating mass gain, and the coating density, stiffness, and adhesion were measured. The tantalum and nickel coatings were largely unaffected by plume quenching with respect to deposition efficiencies, coating density, adhesion, and stiffness. These results indicate that a plume quench could be used without affecting the coating properties for high- and medium-density metals while providing the benefit of substrate cooling that increases with higher plume quench gas flow rates.

The mechanical integrity of WC-Co coatings is critical for their performance in wear, corrosion, and impact resistance applications. Residual stress, with its role in development of cracking, micro-cracking, and delamination, is another integral part of the mechanical characterization of the coated systems. In the given study, the residual stress of the WC-Co coatings on steel and stainless steel substrates was examined in two conditions, after deposition and after subsequent surface grinding. Several experimental techniques, including bi-layer curvature, X-ray diffraction, and neutron diffraction, were used to assess residual stress in the coatings and to enable comparison between the methods. Residual stresses induced by deposition are mostly due to rapid particle quenching and solidification upon impact, as well as any cold working induced by high velocity particle impact, but for the WC ceramic particles both effects are insignificant and result in small deposition stress. Thermal mismatch between materials of coating and substrate is the major source of stress and scale accordingly to the CTE of the substrate and coating materials and deposition temperature. It was demonstrated that the grinding applied to surface does not modify the as-sprayed residual stresses in the coatings significantly therefore assuming absence of microcracking that could have potentially affect the residual stresses.