The application of IR-Lock-In Thermography (IRLIT) has been extended from 2D and 3D package fault isolation to on-die level analysis. In addition, the technique has become more sensitive allowing for detection of much lower dissipated power. In this paper, several fault localization cases covering PCB assemblies down to die level analysis are discussed using IR-LIT and absolute temperature mapping. Where possible, the analysis is complemented with physical defect verification. The fault isolation cases include an ultra-low power dissipation (<150 nW) and several case studies with high ohmic connections. For the latter a new method based on phase mapping is discussed allowing for 2D localization of thermally invisible defects. The method will be demonstrated on a test vehicle where phase data extracted from a visible feature of the device under test is studied. After this, a case study at die level is presented in an attempt to distinguish the phase information from two stacked M2-M3 metallization layers of the Back-End Of the Line (BEOL). Finally, temperature mapping results of a 5 micron wide aluminum feature in silicon-oxide is presented that is pushing the optical resolution of the tool.

Soft defects localization by laser techniques on dynamically working ICs is widely used for Failure Analysis (FA). In this context, many AC signal-oriented analysis methods have been introduced to date (SDL, LADA…) or are under development (xVM…). Sophisticated tools are available to localize these kinds of failures but not every FA laboratory has them. By fully exploiting the capabilities of static localization tools, it is possible to deal with timing issues. In this paper, we propose a novel application of the OBIRCh amplifier related to the timing issues on a real case study (mixed-mode device). This novel and very simple application makes the analysis flow time-attractive and enlarges the application field of mapping techniques on the existing tools.

Infra-red Thermal Laser Stimulation (TLS) signatures obtained on semiconductor materials can be difficult to interpret and to distinguish from signatures from metallic materials. Investigations presented here consist in the study of TLS signals on unsilicided/silicided polycrystalline and diffused silicon resistors of 0.18µm technology. The influence of each process parameter on the TLS signal has been observed and evaluated from the front and back side of the circuit. This allowed us to quantify the effect of the silicon substrate thickness on TLS signal detection and to determine the ideal silicon thickness for sample preparation. This study also completes our methodology based on the TCR parameter which aims at improving defect localization in the depth (Z) of circuitry. As it will be shown through failure analysis case studies, this methodology increases the physical analysis success rate and reduces the turnaround time.