Anisotropy of stress-strain behavior, fracture toughness, and fatigue crack growth rate was studied for Inconel 738LC alloy built by the Dynamic Metal Deposition technique (3DMD, a high-speed Directed Energy Deposition technique). The measured quasi-static properties, i.e. stress-strain and fracture toughness showed only subtle anisotropy, with no more than 10% differences found for different orientations. The fatigue crack growth rate was influenced by the specimen orientation more significantly (30% for fatigue crack growth threshold, up to 90% for Paris exponent and coefficient). This pilot study attributes the anisotropy of fatigue crack growth properties to material texture and the columnar grain geometry resulting from directional solidification. The obtained testing results indicate that 3DMD technology can produce materials with good mechanical and fracture properties even from materials considered as non-weldable such as In 738LC. The study provides a solid experimental base for further investigation of the fatigue crack growth mechanism relation to the material texture in 3DMD In 738LC.

Anisotropy of stress-strain behavior, fracture toughness, and fatigue crack growth rate of Ti6Al4V deposited by cold spray using nitrogen was studied. For that, flat deposits were tested with stress acting in the in-plane directions and tubular deposits were tested in the out-of-plane stress directions. In all tests, unified small-size specimens were used. It was shown that for the in-plane stress, the deposits can be considered isotropic, whereas the out-of-plane stress led to significantly lower values of the measured properties. The obtained results were related to fractography and microstructural analysis. While a combination of trans-particle and inter-particle fracture determined the fatigue properties in the near-threshold regime, at higher loads, inter-particle fracture was dominant. It was also shown that the different particle-to-stress orientations influenced the resulting fatigue and static properties.

Tungsten heavy alloy (WHA) of W-Ni composition was deposited from a blend of standard thermal spray powders using a radio frequency inductively coupled plasma torch in a protective atmosphere. The coating contained a fully developed WHA structure, i.e., spherical W particles embedded in a Ni-rich matrix. Bending tensile strength R m , bending yield strength R p,0.2 , and elastic modulus were measured and compared with W-Ni-Co references fabricated by sintered and quenched (SQ) and forged and annealed (FA) powder metallurgy (PM) processes. The fatigue and fracture properties of the plasma spray deposits are comparable with those of the SQ-PM reference material, but inferior to those of the FA-PM reference. The results of various property tests are presented and analyzed in the paper.

Fatigue crack growth in self-standing plasma sprayed tungsten and molybdenum beams with artificially introduced notches subjected to pure bending was studied. Beams width, thickness and length was 4 mm, 3 mm and 32 mm respectively. Fatigue crack length was measured using the differential compliance method and fatigue crack growth rate was established as a function of stress intensity factor. Unusual crack opening under compressive loading part of the cycle was detected. Fractographic analysis revealed the respective crack formation mechanisms. At low crack propagation rates, the fatigue crack growth takes place by intergranular splat fracture and splat decohesion for Mo coating. In W coating, intergranular splat fracture and void interconnection formed the fatigue crack. Frequently, the crack deflected from the notch plane being attracted to stress concentrators formed by porosity. At higher values of the stress intensity factor, the splat intergranular cracking become more common and the crack propagated more perpendicularly to the specimen surface.