Because of their high specific strength, carbon fiber reinforced plastics (CFRPs) are widely used in the aerospace industry. Metallization of CFRP by cold spraying as a surface modification method can improve the low thermal resistance and electrical conductivity of CFRP without the need for high heat input. Herein, we cold spray a Sn coating on cured CFRP substrates and examine the Sn/epoxy interface. The results suggest that the Sn coatings are successfully obtained at a gas temperature of 473 K and indicate no severe damage to the CFRP substrates. The stress and plastic strain distributions at the cross-section of the Sn/CFRP interface when a Sn particle is impacted onto the CFRP substrate are obtained using the finite element method.

In this work, a novel liquid fuel HVOF process fueled with ethanol was used to prepare 75wt%Cr 3 C 2 –25wt%NiCr coatings on AISI304 stainless steel substrate. Taguchi method was employed to optimize the spray parameters (ethanol flow rate, oxygen flow rate, powder feed rate and standoff distance) to achieve better erosion resistance at 90° impact angle. The results indicated that ethanol flow rate and oxygen flow rate were identified as the highly contributing parameters on the erosion wear loss. The important sequence of the spray parameter is ethanol flow rate > oxygen flow rate > standoff distance > powder feed rate. The optimal spray parameter (OSP) for minimum erosion wear loss was obtained under ethanol flow rate of 28slph, oxygen flow rate of 420slpm, powder feed rate of 76.7 g/min and standoff distance of 300mm. The phase composition, microstructure, hardness, porosities, and the erosion wear behaviors of the coatings have been studied in detail. Besides, erosion wear testing of the optimized coating was conducted at 30°, 60° and 90° impact angle using air jet erosion testing machine. The SEM images of the erodent samples were taken to analyze the erosion mechanism.

Unlike their metal counterparts, composite structures do not readily conduct away the electrical currents generated by lightning strikes. Cost reduction and expected production growth of the next middle range airplanes require automated manufacturing process of polymer components. The development of an automated technology to metallize polymer based composite for lightning strike protection is the aim of the CO3 project (EU Grant agreement: ID831979). In this study, thermal and electrical conductivities of composites were achieved by cold spray deposition of Cu or Al coatings. Critical points to be addressed were substrate erosion during cold spray, lack of polymer-metal adhesion and poor deposition efficiency. Several strategies were tested: i) a thin polymer film was cocured at the substrate surface before cold spraying, to enable implantation of metallic particles in the film, helping coating build-up and protecting the fibers of the composite. ii) Cold spraying a mix of metal and polymer powders to improve coating adhesion and prevent fiber damage. iii) Supercritical Nitrogen Deposition technology, prior to cold spray, to mechanically anchor metallic particles into the polymer. Subsequent cold spraying of purely metallic coatings was more efficient and showed better adhesion. All coatings were tested in terms of adhesion strength and electrical conductivity.

Masking solutions for parts needing special treatments such as shot peening, grit blasting or thermal spray are now commonly used in industrial processes for the aerospace, industrial gas turbine, and medical industries. The ever-evolving special treatment methods require adapting the masking solutions so they retain their efficiency and quality level. This paper will describe the choices made in combining materials, geometry and surface finish of the masks to provide the necessary compliance with the thermal spraying processes or other special treatment requirements. We will demonstrate that successful masking designs are often the result of close collaboration between the operator’s engineering team and the masking solutions provider in order to comply with what is always a bespoke process. Innovations in materials and additive manufacturing enable the process towards tailored solutions which enable these industries to increase their productivity and level of manufacturing quality.