Molybdenum powder has been plasma sprayed on stainless steel, brass and aluminum substrates. The substrate melting phenomenon is observed and investigated by means of scanning electron microscopy (SEM) and scanning white light interferometery (SWLI). It is found that the flower-shape splat morphology is typical for molybdenum on all three substrate materials when the substrate is at room temperature. Notable substrate melting is manifested through the energy dispersion analysis of X-ray (EDAX) map and Robinson back-scattered image of cross-sections of splats. It has been shown that the substrate material plays an important role in substrate melting phenomenon. The lift angle of the petals of splats and the maximum crater depth have been characterized and compared. Both of these increase in the sequence, from stainless steel, brass to aluminum. A ‘volume of fluid’ (VOF) based model coupled with rapid solidification has been used to simulate splat deformation, solidification, substrate melting and resolidification. The numerical & analytical results agree quite well with the experimental data. A substrate melting mechanism is proposed based on the time scales of the droplet solidification and substrate melting to explain the formation of flower like splat morphologies.

Molybdenum splats were produced at three plasma conditions on steel substrates preheated to three temperatures. Morphology of splats and corresponding craters formed on substrates were observed; dimensions of splats and craters were measured with an optical non-contact interferometer. It is found that substrate is significantly melted and deformed upon impact of the droplet, which leads to the formation of flower like splats and craters. On average, only about 36 to 53 % of the areas covered by splats were in good metallurgical/mechanical contact with substrate. Normalized crater volume increases with droplet size and the contact is improved for the high particle energy/high substrate temperature condition as compared with low particle energy/medium substrate energy condition. Splat morphology and crater formation is explained based on impinging jet heat transfer model.