Abstract
Cobalt chromium (CoCr), a well-known biocompatible material, was additively manufactured using direct energy deposition (DED) technology in this study. Since DED is a relatively new addition to additive manufacturing (AM) processes, there is not enough information about important properties of fabricated parts and components using this technology. This study investigates some important mechanical characteristics of the additively manufactured CoCr using a variety of numerical simulation methods in addition to mechanical tests and experiments. Mechanical experiments such as hardness, wear, and flexural bending test were conducted on DED processed samples. All experiments were also conducted on conventionally processed CoCr specimens for comparison purposes. This study attempts to explain mechanical properties in terms of microstructural characteristics of each sample. DED processed CoCr samples exhibited a complex microstructure with a variety of features such as cellular, columnar, and equiaxed grains within their melt pools. While the DED processed sample had a lower hardness compared to the conventionally processed one, it exhibited a higher wear resistance. These results were discussed in terms of microstructural characteristics and metallurgical bonding knowing that porosity level was negligible in both samples. The out-of-plane mechanical strength of CoCr samples was measured by conducting flexural bending test, and the conventional sample showed a higher flexural modulus than the DED sample. The bend tests were also numerically simulated using two different finite element analysis (FEA) procedures. The FEA results for the DED and conventionally processed samples follow the same trend as the results obtained from the experimental flexural bending test. The layer structure and interfacial bonding of the DED sample could have contributed to the lower flexural modulus compared to the conventional sample.
