Abstract
Light alloys are being investigated as an alternative to ferrous-based engineering components. The manufacturing of such components requires a surface modification step necessary to eliminate the top surface's poor wear and corrosion response for improved functionality. Thermally sprayed cermet coatings offer improved surface resistance to wear and/or corrosion. This work presents a customized composition of WC-CoCr feedstock cut in fine and coarse powder size distribution (PSD) to fabricate different coatings on aluminium alloy and steel substrates using two high velocity spray techniques. The WC-CoCr coatings sprayed using the high velocity air-fuel (HVAF) technique at varied parameters consist of six different coatings (four thick, ~ 200 μm and two thin ones, 60-80 μm) to investigate the relationship between processing conditions, microstructure, and performance. Using scanning electron microscopy (SEM) and electro-dispersive X-ray spectroscopy (EDX) offered a comprehensive characterization of the respective coatings. Micro indentation, dry sliding wear, dry sand abrasion, and cavitation erosion tests conducted on the samples show the performance of the coatings based on the processing techniques and spray conditions. However, despite the similarities in the microstructural makeup of the coatings and the measured micro indentation hardness of the coatings (1000-1300 HV0.1), their respective specific wear rate (SWR) varied based on spray processing techniques and the substrate on which the coatings were deposited. Three of the HVAF coatings showed ~ 60 % more wear on the aluminium alloy substrate compared to the same coating deposited on a steel substrate. However, irrespective of the substrate used the HVAF coatings showed better wear resistance than the HVOF coating. The dry sand abrasion wear results of the two thick HVAF coatings show them superior to the HVOF coating in the three-body wear experiment conducted. The cavitation erosion resistance of the coatings varied based on the processing conditions and the driving mechanisms but the best two were the AF-2 and AF-6 samples.
