This paper presents the results of an investigation to gain a better understanding of the impact of wafer substrate copper (Cu) contamination on FinFET devices. A chip from a wafer free of Cu contamination and several chips near a Cu contaminated wafer edge were sampled for chemical, structural, and morphological analysis and electrical device performance testing. The contaminated wafer was also annealed at high temperature, trying to drive Cu diffusion further into the Si substrate. TEM analysis revealed that the Cu interacted with Si to form a stable η-Cu 3 Si intermetallic compound. SIMS analysis from the backside of the wafer detected no Cu even after most of the backside material was removed. Likewise, electrical nanoprobing showed no parametric drift in the FinFETs near the edge of the wafer, comparable to device behavior in a Cu-free Si substrate. These results indicate that the formation of η-Cu 3 Si with a well-defined crystalline structure and stable stoichiometry immobilizes Cu diffusion in the Si substrate. In other words, the impact of Cu diffusion in silicon has no effect on device performance as long as η-Cu 3 Si does not form in the FinFET channel or short any structures within the chip.

The effect of ash chemistries, N2/H2 and H2, on time-dependent dielectric breakdown (TDDB) lifetime has been investigated for Cu damascene structure with a carbon-doped CVD ultra low-k (ULK, k=2.5) intermetal dielectric. Two failure modes, interfacial Cu-ion-migration and Cu diffusion through the bulk intermetal ULK were attributed to the TDDB degradation for the H2 ash.The interfacial Cu-ion-migration was the only dominated failure mode for the N2/H2 ash. The nitrogen species in the N2/H2 plasma proved to be capable of forming a nitrided protection layer on the surface of the ULK. This nitrided layer suppressed further plasma damage during the ash process and thus lessened the TDDB degradation by preventing Cu diffusion through the bulk ULK.