The continuously growing demands in high-density memories drive the rapid development of advanced memory technologies. In this work, we investigate the HfOx-based resistive switching memory (ReRAM) stack structure at nanoscale by high resolution TEM (HRTEM) and energy dispersive X-ray spectroscopy (EDX) before and after the forming process. Two identical ReRAM devices under different electrical test conditions are investigated. For the ReRAM device tested under a regular voltage bias, material redistribution and better bottom electrode contact are observed. In contrast, for the ReRAM device tested under an opposite voltage bias, different microstructure change occurs. Finite element simulations are performed to study the temperature distributions of the ReRAM cell with filaments formed at various locations relative to the bottom electrode. The applied electric field as well as the thermal heat are the driving forces for the microstructure and chemical modifications of the bottom electrode in ReRAM deceives.

In this paper, the stacking fault defects in FinFETs are described as the root cause of the PLL failure. Failure analysis approaches such as photon emission microscopy and nano probing were applied to pinpoint the exact stacking fault location in even transistor level and High resolution TEM confirmed the stacking fault defects in the Fin which was isolated by nano probing. RX local density was confirmed as the key factor in stacking fault generation by TCAD simulation. RX new mask with dummy addition was made to mitigate stress and was confirmed to be effective to reduce the compressive strain at the channel in FinFETs by Geometric Phase Analysis (GPA) which provided sufficiently practical local strain measurement data. The GPA techniques demonstrated here are informative for process improvement and failure analysis in FinFET devices. Keywords – Stacking Fault, Geometric Phase Analysis

Application of the high resolution of Transmission Electron Microscopy (HRTEM) plays a very important role in structural analysis and materials characterization for process evaluation and failure analysis in the Integrated Circuit (IC) industry. We summarize TEM observation experience of the common memory failures of a BEST deep trench cell with an N-MOS gate used in CMOS DRAM technology. Memory cell failures are categorized into three areas for discussion – the deep trench (DT) capacitor, the transfer gate (GC), and the borderless bit-line contact (CB) between a transistor and a bit line. Typical examples that occurred in these three areas are presented and provide a basic understanding of normal DRAM cell failures.

As MOSFET device gate lengths shrink below the 130 nanometer node, the effects of short channel effects (SCE) and gate line edge roughness (LER) have an increasingly more pronounced affect on device performance [1-8, 10]. The 2001 International Technology Roadmap for Semiconductors (ITRS) predicts increasingly tighter critical dimensions (CD) control limits on LER from 2.7 nm in 2004 to 1.3 nm in 2010 [9,11]. As gate lengths shrink, resist etch processes emerge as the most significant contributor to LER [1-8, 11]. In addition, another contributing factor to SCE is junction implant defects. Examples of gate LER effects and junction defects in 130 nanometer node SOI SRAM MOSFET devices identified by sub-micron electrical characterization with analysis by high resolution transmission electron microscopy (TEM) are discussed.