In this study, the challenges to transfer the microelectronics failure analysis techniques to the photovoltaic industry have been discussed. The main focus of this study was the PHEMOS as a tool with strong technological research capacity developed for microelectronics failure analysis, and OBIC (Optical Beam Induced Current) as a non-destructive technique for detecting and localizing various defects in semiconductor devices. This failure analysis tool was a high resolution optical infrared photon emission microscope used mainly in microelectronics for qualitative analysis and localization of semiconductor defects. Such failure analysis equipment was designed to meet requirements for modern microelectronic devices. Characterization of current photovoltaic device often requires quantitative analysis and should provide information about the electrical and material properties of the solar cell. Therefore, in addition to the demand for further data processing of the obtained results we had to study the corresponding operating regime of solar cells to allow for a correct interpretation of measurement results. In this paper, some of the related problems we faced during this study, e.g. large amount of data processing, the spatial misalignment of the images obtained as EL (Electroluminescence) and IR-LBIC (Infrared Light Beam Induced Current), the implemented laser wavelength, its profile and power density for IR-LBIC measurement. These topics have been discussed in detailed to facilitate a reliable transfer of these techniques from microelectronics to the photovoltaic world.

In this paper, IR-LBIC (Infrared Light Beam Induced Current) is applied using the laser wavelength of 1064 nm in order to analyze polycrystalline thin-film solar cells. The spatially high-resolved map of the short circuit current (~3 µm) has been obtained by performing the IR-LBIC measurement. The results of the measurement showed higher signal response from the grain boundary compared to that from the grain interior. This difference has been explained by the light trapping effect due to the trench-shaped grain boundary profile, which is possibly accompanied by two stage excitation effects via electronic grain boundary states. It has been additionally investigated, whether LBIC measurement could be used to extract local illuminated cell characteristics. However, since the dark current, which has a decisive influence on the solar cell characteristic, is flowing in the entire cell area, this is not possible. A circuit network simulation demonstrates that LBIC cannot be used for extraction of the local open circuit voltage, and the short circuit current is the only parameter that can be locally defined and therefore clearly observed.

The temperature dependence of photocurrent of polycrystalline Si (poly-Si) thin-film solar cells on glass with interdigitated mesa structure has been locally investigated using Infrared Light Beam Induced Current (IR-LBIC) in the temperature range of -25 to +70 °C. The temperature dependence of electrical characteristics of poly-Si thin-film solar cells in reverse bias has been also analysed and compared with the monocrystalline thin-film solar cells. The poly-Si solar cell shows a temperature coefficient (TC) for the photocurrent of around +0.8 and +0.6 %/°C in the grain interior and grain boundary, respectively. The activation energy of the reverse current and also the photocurrent due to the IR laser stimulation has been evaluated, which provide information about traps and their energy levels in the absorber layer of the poly-Si thin-film solar cell. The obtained average value of the activation energy associated with the photocurrent of the poly-Si cell suggests the existence of a shallow acceptor level at around 0.045 eV in the grain boundary and 0.062 eV in the grain interior of the absorber layer of the poly-Si thin-film solar cell. The activation energies of the reverse current for poly-Si and monocrystalline cells have been calculated when the device is biased at -1 and -2 V and the results compared with the activation energy of the saturation current obtained from extrapolation of the I-V curve in the SRH (Shockley-Read-Hall) regime. The results show strong voltage dependence. In both cases the activation energy of the reverse current decreases in the reverse bias voltage, approaching the values obtained from the photocurrent.

The carrier collection properties of polycrystalline Si (poly-Si) thin film solar cells on glass with interdigitated mesa structure have been locally analysed with Infrared Light Beam Induced Current (IR-LBIC) and compared to LBIC measurements using visible light. The low absorption of IR light leads to a low current level when the light is coupled vertically into the active volume. An enhanced carrier collection has been detected at the corners of the mesa because the etch allows to couple the light horizontally into the solar cell, This investigation shows that IR-LBIC is sensitive to light trapping structures in silicon based thin film solar cells.