Search Results for total

Fig. 2 The total x-ray diffraction pattern for silica glass. I t is the total diffracted intensity; I b is the background intensity; and s = 4π sinθ/λ. The ordinate is multiplied by a factor of 1, 3, and 9 in the three sets of curves. More

Fig. 4 Typical total ion chromatogram. A plot of the total ion intensity versus time More

Fig. 4 Total ion chromatogram (plot of total ion intensity versus time) obtained with electron ionization gas chromatography/mass spectrometry for the kerosene-based jet fuel JP-8 More

Fig. 14 Total life versus silicon content for 80Ni-20Cr alloys. Total life was determined for 0.64 mm (0.025 in.) diam wire in intermittent tests in air at 1175 °C (2150 °F). More

Fig. 10 Total consumption burner. More

Fig. 8 Total luminescence spectrum (EEM) of a mixture of naphthalene and anthracene. More

Fig. 6 Change in amplitude of the total diffracted beam as a function of the scattering angle. Higher scattering angles result in greater phase differences among the diffracted beams, decreasing the amplitude of the total diffracted beam. More

Fig. 5 Diffraction data for an activated carbon (Amoco PX-21). I t is the total diffracted intensity, SAXS is the small-angle x-ray scattering obtained from the Fourier transform of the average density envelope, and I t — SAXS represents the total intensity with the small-angle More

Fig. 3 Schematic of gradients in fatigue initiation driving force (shown as total stress) and fatigue resistance (fatigue strength) that can result in subsurface initiation in a case-hardened component. Total stress includes applied plus residual stress. The surface is located at the left More

Fig. 15 Total strain range versus cycles to failure for isothermally annealed 2.25Cr-1Mo steel at 427 and 538 °C (800 and 1000 °F). Source: Ref 21 More

Fig. 31 Percentage of total valve recession caused by impact and sliding More

Fig. 9 Total positive ion image of stainless steel surface (50 by 50 μm) revealed by TOF-SIMS More

Fig. 72 Micrographs showing different degrees of decarburization. (a) Total decarburization caused by a furnace leak during gas carburizing of AISI 1018 steel. 500×; 1% nital etch. (b) Partially decarburized specimen. 190×. Source: Ref 30 More

Fig. 24 Total expected life-cycle cost as a function of safety index More

Fig. 9 Bar graph showing the variation in total crack length between low-cobalt bearing, standard, and cobalt-free 18Ni(250) maraging steels following K Iscc testing in a marine atmosphere. Heat treatment: 815 °C (1500 °F), 1 h, air-cooled; 480 °C (900 °F), 5 h, air-cooled. Source: Ref 12 More

Fig. 3 Rupture life versus volume fraction of fine γ′ at a fixed total amount of fine and coarse γ′ for DS MAR-M 200 Hf alloy More

Fig. 11 Total suspended particulate high-volume ambient-air monitors are commonly used on lead-paint-removal projects as a means to quantify emissions from the containment. More

Fig. 3 Example takeoff of the surface area of a project. The total area of the structure is the sum of the surface area of its pieces. More

Fig. 11 Attenuated total reflectance attachment used when performing infrared spectroscopic analysis reflectance technique. Courtesy of KTA-Tator, Inc. More

Fig. 13 Correlation of hardness to drilling time (total time for drilling 25 holes) More