1-20 of 591 Search Results for

hand feeding

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Image
Published: 01 January 2006
Fig. 14 Bracket that was made by hand feeding stock into a progressive die to avoid the jamming that would have been likely from automatic feeding. Dimensions given in inches More
Image
Published: 01 January 2001
Fig. 3 Hand-feed drill motor with hydraulic dash pot for feed control More
Book Chapter

Series: ASM Handbook
Volume: 14B
Publisher: ASM International
Published: 01 January 2006
DOI: 10.31399/asm.hb.v14b.a0005115
EISBN: 978-1-62708-186-3
... Abstract This article commences with a description of the four basic types of feeding arrangements, namely, hand feeding, hitch feeds, roll feeds, and slide feeds. Air feeds offer the utility of use with a wide variety of presses and machines. The article discusses the mounting and actuation...
Image
Published: 31 October 2011
Fig. 10 Typical automatic stud-feed hand-gun system for portable operation using templates or fixtures on the workpiece More
Image
Published: 01 January 1993
Fig. 10 Typical automatic stud-feed hand-gun system for portable operation using templates or fixtures on the workpiece More
Series: ASM Handbook
Volume: 21
Publisher: ASM International
Published: 01 January 2001
DOI: 10.31399/asm.hb.v21.a0003426
EISBN: 978-1-62708-195-5
... for hand drilling at 18,000 to 20,000 rpm usually with hard tooling is shown in Fig. 2 . One key to successful hole drilling is feed control. If the cutters are hand fed through the materials with no controls, composite materials are susceptible to breakout damage and delaminations. Two methods to reduce...
Book: Machining
Series: ASM Handbook
Volume: 16
Publisher: ASM International
Published: 01 January 1989
DOI: 10.31399/asm.hb.v16.a0002194
EISBN: 978-1-62708-188-7
... ultrasonic drilling machine turning at 2000 to 3000 rev/min with axial vibration. The drill point was coated with 80-grit diamond. Reaming can be done with standard high-speed steel reamers, using a hand feed and surface cutting speed of 4.5 to 6 m/min (15 to 20 sfm) and a generous supply of cutting...
Image
Published: 01 January 1994
Fig. 10 Broach and carbide mill reamers. (a) Broach reamer, made of high-speed steel with a left-handed helix of 60° or more, that can cut at 20 m/min (65 ft/min) at a feed of 0.25 mm/rev (0.1 in./rev). (b) Carbide mill reamer that can cut at 30 m/min at a feed of 0.3 mm/rev (0.1 in./rev) More
Series: ASM Handbook
Volume: 14B
Publisher: ASM International
Published: 01 January 2006
DOI: 10.31399/asm.hb.v14b.a0005112
EISBN: 978-1-62708-186-3
... describes the roles of automatic handling equipment that can be categorized as feeding equipment, unloading equipment, and transfer equipment. It concludes with information on the common types of high-production presses, such as dieing machines, multiple-slide machines, transfer presses, fine blanking...