1-6 of 6 Search Results for

end-cutting reamers

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Series: ASM Desk Editions
Publisher: ASM International
Published: 01 December 1998
DOI: 10.31399/asm.hb.mhde2.a0003192
EISBN: 978-1-62708-199-3
... recommendations for the range of speeds and feeds for various machining operations, parameters for the selection of tool geometry, and guidelines on the selection and identification of cutting fluids. cutting fluid recommendations cutting speed recommendations drilling end milling face milling...
Series: ASM Handbook
Volume: 5
Publisher: ASM International
Published: 01 January 1994
DOI: 10.31399/asm.hb.v05.a0001231
EISBN: 978-1-62708-170-2
... (45 HRC), and in such cases CBN inserts can be used. As with turning, ultraprecision milling is gaining ground, and a recent development is shown in Fig. 5(a) . Single-crystal diamonds are used and mirror-like surfaces are obtained. With the development of diamond pseudo-end mills it is possible to...
Book Chapter

Series: ASM Desk Editions
Publisher: ASM International
Published: 01 December 1998
DOI: 10.31399/asm.hb.mhde2.a0003188
EISBN: 978-1-62708-199-3
... plastic deformation at relatively low cutting speeds (30 to 60 m/min, or 100 to 200 sfm). As a result, their primary applications are in form cutters, reamers, taps, drills, and small-diameter end mills. High-speed steels are also used in the milling of high-temperature materials and on older machines...
Book Chapter

Series: ASM Desk Editions
Publisher: ASM International
Published: 01 December 1998
DOI: 10.31399/asm.hb.mhde2.a0003114
EISBN: 978-1-62708-199-3
...-speed steels and tungsten high-speed steels are similar in many other respects, including hardening ability. Typical applications for both categories including cutting tools of all sorts, such as drills, reamers, end mills, milling cutters, taps, and hobs. Some grades are satisfactory for cold-work...
Series: ASM Handbook
Volume: 5
Publisher: ASM International
Published: 01 January 1994
DOI: 10.31399/asm.hb.v05.a0001276
EISBN: 978-1-62708-170-2
... electrostatic application in coil or sheet stock. To ensure an adequate coat, the material should be applied according to the specifications supplied by the end user. Oil-based compounds used on coil or sheet stock are applied by using the roll-coater spray and electrostatic methods, which allow some control of...
Series: ASM Handbook
Volume: 5
Publisher: ASM International
Published: 01 January 1994
DOI: 10.31399/asm.hb.v05.a0001243
EISBN: 978-1-62708-170-2
... largest diesel crankshafts and bores of large naval guns and M-16 rifles are hard chromium plated on a production basis. Internal surfaces of very large cylinders have been plated by closing off the ends of each cylinder and retaining the plating solution with it. Most hard chromium deposits are applied...