1-20 of 579 Search Results for

die bearings

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Series: ASM Handbook
Volume: 18
Publisher: ASM International
Published: 31 December 2017
DOI: 10.31399/asm.hb.v18.a0006385
EISBN: 978-1-62708-192-4
..., such as: Initial billet temperature Flow stress of the alloy at the extrusion temperature, strain, and strain rate Plastic deformation (including both homogeneous and redundant work effects) Friction at the billet container, dead-metal flowing material, and die-bearing flowing material interfaces Heat...
Series: ASM Handbook
Volume: 2A
Publisher: ASM International
Published: 30 November 2018
DOI: 10.31399/asm.hb.v02a.a0006534
EISBN: 978-1-62708-207-5
..., representing the minimum amount of work needed to change the shape of the billet into the final product Pressure required to overcome the surface friction (at the container wall friction, dead-metal zone friction, and the die bearing friction) Pressure required to overcome redundant or internal...
Published: 01 January 1989
Fig. 34 Die cast engine block that was honed with gray iron bearing caps in place, and honing tool that was used (bottom). Dimensions in figure given in inches Speed, at 900 rev/min, m/min (sfm) 190 (620) Spindle reciprocation rate, strokes/min 60 Hone speed, m/min (sfm) 21 (70 More
Series: ASM Handbook
Volume: 2B
Publisher: ASM International
Published: 15 June 2019
DOI: 10.31399/asm.hb.v02b.a0006553
EISBN: 978-1-62708-210-5
... alloys bearings. A table lists selected applications for aluminum casting alloys. cast aluminum alloys cast aluminum alloys bearings cast rotor alloys elevated-temperature casting alloys high-integrity die casting alloys high-strength casting alloys moderate-strength alloys wear-resistant...
Book Chapter

Series: ASM Handbook
Volume: 14B
Publisher: ASM International
Published: 01 January 2006
DOI: 10.31399/asm.hb.v14b.a0005114
EISBN: 978-1-62708-186-3
... the top surface of the punch holder ( Fig. 1 ). Fig. 1 Die-set nomenclature Generally, the guide bushings are assembled to the punch holder and the guide posts to the die holder. This arrangement is normally reversed when ball-bearing bushing assemblies are used. The Shank: Functions...
Published: 01 January 2005
Fig. 19 F-15 bearing supports weighing 21.1 kg (46.5 lb) individually, made of Ti-6Al-4V that was finish forged with a hot-die near-net forging process in Astroloy dies at 925 °C (1700 °F). Bearing supports were finish forged as doubles More
Series: ASM Handbook
Volume: 20
Publisher: ASM International
Published: 01 January 1997
DOI: 10.31399/asm.hb.v20.a0002486
EISBN: 978-1-62708-194-8
... and selection of materials can ensure the most cost-effective product design. Fig. 14 How material selection affects process Bearings Due to the unique self-lubricating character