1-20 of 239 Search Results for

Connectors

Sort by
Image
Published: 01 January 1994
Fig. 3 Examples of plastic composite connectors plated with electroless copper and nickel. Courtesy of Shipley Co. More
Image
Published: 01 January 2000
Fig. 14 Shear stresses in load end connectors. (a) A clevis and pin connected to the eye in Fig. 13(a) . (b) Shear planes in the pin. (c) Shear planes in the eye More
Image
Published: 15 January 2021
Fig. 5 Fretting wear damage in electrical connectors More
Image
Published: 01 January 1986
Fig. 11 LEISS spectrum from a stained connector. The connector surface consists primarily of sulfur, copper, and silver. More
Image
Published: 01 January 1990
Fig. 7 Ratio of yield strength to elastic modulus for several connector alloys More
Image
Published: 01 January 1990
Fig. 9 Isochronal (1000-h) stress relaxation behavior of selected connector alloys at an initial stress level of 50 to 75% of the room-temperature 0.2% offset yield strength More
Image
Published: 01 January 1990
Fig. 14 Product of electrical and thermal conductivity for selected connector alloys. The product is inversely proportional to the temperature increase in a current-carrying contact beam. More
Image
Published: 31 October 2011
Fig. 1 Fiber optic cable connector. Courtesy of IPG Photonics More
Image
Published: 01 January 2006
Fig. 3 Effects of water being trapped inside a connector. The high-voltage pin (anode) is completely corroded off (right side), while the ground pins (cathodes) exhibit no corrosion. The pins in between are at lower voltages and show a lesser degree of corrosion. More
Image
Published: 01 January 2006
Fig. 14 Interior of failed electrical connector showing corroded pins More
Image
Published: 01 January 2006
Fig. 2 Corrosion of gold-plated connector along with energy-dispersive x-ray analysis elemental maps of Au, Cu, O, Ni, and Cl More
Image
Published: 01 January 2002
Fig. 4 Sand-cast low-alloy steel eye connector from a floating-bridge pontoon that broke under static tensile loading. (a) Schematic illustration of pontoon bridge and enlarged view of eye and clevis connectors showing location of fracture in eye connector. (b) A fracture surface of the eye More
Image
Published: 01 January 1989
Fig. 6 Electronic-connector network photochemically blanked from predrilled 1.1 mm (0.042 in.) thick nickel sheet. Dimensions given in inches More
Image
Published: 01 January 2000
Fig. 15 Shear planes in a threaded end connector More
Image
Published: 01 January 1993
Fig. 17 Connector methodologies More
Image
Published: 30 June 2023
Fig. 8 XY 2–100 protocol. (a) DB-25 pin layout and connector wiring. (b) Transmission timing diagram. CK, clock; SYNC, synchronization; CH, channel More
Image
Published: 01 January 2000
Fig. 13 Methods of connecting loads. (a) A load is applied to the tie bar in Fig. 1 by a pin/eye connector and a threaded connector. (b) End loads are applied to a composite bar by adhesives. More
Series: ASM Handbook
Volume: 13C
Publisher: ASM International
Published: 01 January 2006
DOI: 10.31399/asm.hb.v13c.a0004129
EISBN: 978-1-62708-184-9
... corrosion control aspects, such as the position of printed circuit boards (PCBs) and proper location of connectors for insertion of the PCBs. It discusses various materials and alloys considered for connectors, PCB contacts, and circuits. The article concludes with a discussion on the effects...
Image
Published: 01 January 2005
Fig. 38 Pits were noticed in the bottom of a type 304 stainless steel three-way flange connector in a food-processing plant when viewed from above. The hot, acidic food (fruit products) passed through this location several times for each production batch. The system was sterilized in place More
Image
Published: 15 May 2022
Fig. 8 A new material was needed after cracking occurred in this electrical connector. More