The appearance, morphology, and extent of the casting skin are the consequence of mold-metal interface interaction. This article discusses the classification of the mold-metal interaction based on severity: mild mold-metal interaction and severe mold-metal interaction. The casting surface exhibits some roughness, which depends on the molding materials used in the casting process. The article describes the effects of the casting skin in spheroidal graphite (SG) and compact graphite (CG) irons, as well as the mechanism of casting skin formation. It discusses the physics of liquid metal penetration in sand molds and concludes with information on the effect of sand additives and mold coatings.

Modeling of gas evolution during sand mold castings is one of the most important technical and environmental issues facing the metal casting industry. This article focuses on describing the capability of numerically predicting gas evolution for the furan binder/silica sand system. It illustrates numerical modeling to study the gas evolution from furan binder/silica sand mold aggregate for aluminum, cast iron, and steel alloy cast components. The article discusses simulation results and experimental validation for aluminum alloys, cast iron castings, and steel alloys, as well as a parametric study that investigated the effects of various variables. It concludes with information on the application of 3-D modeling methodology to investigate gas emissions in furan binder/silica sand castings for steel 4140 and aluminum A356 alloys.

This article reviews the production stages of iron foundry casting, with particular emphasis on the melting practices, molten metal treatment, and feeding of molten metal into sand molds. It discusses the molten metal treatments for high-silicon gray, high-nickel ductile, and malleable irons. Foundry practices are also described for compacted graphite, high-silicon ductile, and high-alloy white irons.

Vertical centrifugal casting machines, installed below the ground level for maximum operator safety, are used for producing bushings and castings that are relatively large in diameter and short in length. This article discusses the mold design for different types of sand molds and permanent molds and their production considerations. It describes the speed of rotation, mold speeds curves, and pouring techniques that are considered in the operation of vertical centrifugal casting machines.

This article begins with a schematic illustration of basic principles of sand molding. It discusses the general design factors, such as parting lines, location of radii, bosses and undercuts, and rib locations, of sand molding. The article schematically demonstrates alternative design solutions to molding and coring problems and describes the molding sequence. Draft refers to the amount of taper given to the sides of a pattern to enable it to be withdrawn easily from the mold. The article concludes with a simple example demonstrating the influence of a casting requirement on the direction of draft.

This article discusses classification of foundry processes based on the molding medium, such as sand molds, ceramic molds, and metallic molds. Sand molds can be briefly classified into two types: bonded sand molds, and unbonded sand molds. Bonded sand molds include green sand molds, dry sand molds, resin-bonded sand molds, and sodium silicate bonded sand. The article describes the casting processes that use these molds, including the no-bake process, cold box process, hot box process, the CO2 process, lost foam casting process and vacuum molding process. The casting processes that use ceramic molds include investment casting, and plaster casting. Metallic molds are used in permanent mold casting, die casting, semisolid casting, and centrifugal casting.