Skip Nav Destination
ASM Handbook
Metalworking: Sheet Forming
Edited by
ASM International
Volume
14B
ISBN electronic:
978-1-62708-186-3
Publication date:
2006
Book Chapter
Die Sets
-
Published:2006
Page range:
221 - 225
Abstract
This article briefly describes the nomenclature, alignment and geometrical considerations, and functional and application requirements of a die set. The die set consists of the shank, guide posts, guide bushings, the punch, and die holders. The article illustrates plate flatness and parallelism in the die set. The testing for abrasion, seizure, and endurance in the die set are discussed briefly. The article concludes with information on die-set recommendations.
You do not currently have access to this chapter.
Citation
Die Sets, Metalworking: Sheet Forming, Vol 14B, ASM Handbook, Edited By S.L. Semiatin, ASM International, 2006, p 221–225, https://doi.org/10.31399/asm.hb.v14b.a0005114
Download citation file:
Related Book Content
Corrosion Fatigue of the Tail Wire of an Aerial Clamp
ASM Failure Analysis Case Histories: Household Products and Consumer Goods
Adhesive Wear Failures
Failure Analysis and Prevention (2021 Edition)
Deep Drawing
Metalworking: Sheet Forming
Fine-Edge Blanking
Metalworking: Sheet Forming
Aqueous Corrosion-Wear Interactions
Corrosion: Fundamentals, Testing, and Protection
Wear of Stainless Steels
Friction, Lubrication, and Wear Technology
Friction, Lubrication, and Wear of Gears and Wind-Turbine Components
Friction, Lubrication, and Wear Technology
Friction and Wear of Seals
Friction, Lubrication, and Wear Technology