Skip to Main Content
Skip Nav Destination


Drawing is a process by which a workpiece is pulled against a die to produce a wire, bar, or tube with smaller cross sectional area compared with the initial stock. This article discusses the variables that affect the drawing process and the parameters that influence friction, lubrication, and wear. These parameters include process, lubricant, workpiece, and tooling. The article provides information on dry and wet lubrication in wire drawing. The dry lubrication refers to use of solid lubricants while wet lubrication refers to the practice of providing a liquid lubricant to the workpiece-die interface. The article describes the most common types and causes of die wear: abrasive wear, adhesive wear, surface fatigue wear, thermal fatigue wear, and catastrophic failure. It concludes with a discussion on the surface treatment and texturing that are used to reduce die wear in drawing operations.

You do not currently have access to this chapter.
Don't already have an account? Register

Gracious Ngaile, James Lowrie, Lubrication and Wear in Drawing Operations, Friction, Lubrication, and Wear Technology, Vol 18, ASM Handbook, Edited By George E. Totten, ASM International, 2017, p 768–783,

Download citation file:

Close Modal

or Create an Account

Close Modal
Close Modal