Skip to Main Content
Skip Nav Destination

Abstract

This article discusses the tribology of three main sheet forming processes: deep drawing, bending, and shearing. For each process, the basic principle of the forming process is briefly explained. Tribological phenomena observed in each process, such as wear and galling, are presented. Common methods of using lubricants and coatings in sheet forming processes are also described.

You do not currently have access to this chapter.
Don't already have an account? Register

Kuniaki Dohda, Numpon Mahayotsanun, Tatsuya Funazuka, Lubrication and Wear in Sheet Forming, Friction, Lubrication, and Wear Technology, Vol 18, ASM Handbook, Edited By George E. Totten, ASM International, 2017, p 808–816, https://doi.org/10.31399/asm.hb.v18.a0006425

Download citation file:


Close
Close Modal

or Create an Account

Close Modal
Close Modal