Skip to Main Content
Skip Nav Destination


The primary objectives of the rolling process are to reduce the cross section of the incoming material while improving its properties and to obtain the desired section at the exit from the rolls. This article illustrates a rolling sequence for the fabrication of bars, shapes, and flat products from blooms, billets, and slabs. It describes two methods for shapes or sections: universal rolling and caliber rolling. The article provides information on two-high mills and three-high mills. Specialty mills for thin sheets, namely, the Sendzimir mill and planetary mill, are discussed. The article analyzes the components of a computer controlled system for high-speed mills. Steels and nonferrous materials are also discussed. The article concludes with information on the defects in flat, bar, or shaped products due to heating and rolling practices.

You do not currently have access to this chapter.
Don't already have an account? Register
Close Modal

or Create an Account

Close Modal
Close Modal