1-20 of 280 Search Results for

geometry

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Image
Published: 01 January 2002
Fig. 11 Geometry of the chamfered and radiused edges used by Lodge More
Image
Published: 01 June 2019
Fig. 7 Geometry of notch machined into tensile specimen to simulate surface defect. More
Image
Published: 01 June 2019
Fig. 1 Schematic of weld joint geometry, noting the location of the observed cracking More
Image
Published: 01 June 2019
Fig. 1 Plot of film thickness versus pinion roll angle for gear tooth geometry of a scuffed gearset. Minimum specific film thickness, A min , 0.073; probability of wear, >95% More
Image
Published: 01 June 2019
Fig. 3 Plot of film thickness versus pinion roll angle for gear tooth geometry that was optimized for maximum scuffing resistance. λ min , 0.097; probability of wear, 94% More
Image
Published: 15 January 2021
Fig. 11 Flaw shape factor, Q , and geometry correction factor, M , for a tension-loaded bar with a semielliptical surface flaw. Source: Ref 12 , ASME XI More
Image
Published: 15 January 2021
Fig. 19 Draw-bead friction test. (a) Configuration of deformation geometry. (b) outline of the test assembly. Adapted from Ref 74 More
Image
Published: 15 January 2021
Fig. 11 Geometry of steam vent line in Japanese power plant and erosion-hole geometry. Source: Ref 62 More
Image
Published: 15 January 2021
Fig. 12 (a) Schematic showing time-of-flight diffraction (TOFD) inspection geometry across a weld. PCS, probe center separation. (b) Portable system with manual TOFD yoke and transducers. Used with permission of Olympus More
Image
Published: 01 December 2019
Fig. 3 Specimen geometry for monotonic and cyclic tests (all dimensions in mm) More
Image
Published: 01 December 2019
Fig. 10 Geometry used in the finite-element analysis for the Design 1 drive shafts More
Image
Published: 01 December 1993
Fig. 1 Finite-element model showing geometry of turbine impeller More
Image
Published: 01 December 1993
Fig. 10 Macroetched cross section through a gear tooth showing the geometry and thickness of the hardened case. Note the irregular case depth. Nital etchant, 1.86× More
Image
Published: 15 May 2022
Fig. 11 Schematic puncture test geometry More
Image
Published: 15 May 2022
Fig. 15 Axisymmetric representation of the geometry for the finite-element puncture test model More
Image
Published: 15 May 2022
Fig. 49 Loading geometry for ASTM D648 heat-deflection temperature test More
Image
Published: 15 May 2022
Fig. 9 Rate sweep of PDMS (polydimethylsiloxane) with Parallel Plate (PP) geometry, with normal stress data displayed More
Image
Published: 15 May 2022
Fig. 26 Torsion rectangular geometry More
Image
Published: 15 May 2022
Fig. 18 Puncture test geometry More
Image
Published: 30 August 2021
Fig. 6 Effect of weld geometry on solidification cracking susceptibility. Reprinted from Ref 10 with permission from The Lincoln Electric Company More