1-6 of 6 Search Results for

Steering arms

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Series: ASM Failure Analysis Case Histories
Volume: 2
Publisher: ASM International
Published: 01 December 1993
DOI: 10.31399/asm.fach.v02.c9001005
EISBN: 978-1-62708-215-0
...Abstract Abstract Several heavy truck Cr-Mo steel steering arms in service less than three years fractured during stationary or low-speed turning maneuvers that required power-assisted steering. Metallographic examination of the cracked AISI 4135 arms, heat treated to a hardness of 285 to 341...
Series: ASM Failure Analysis Case Histories
Publisher: ASM International
Published: 01 June 2019
DOI: 10.31399/asm.fach.conag.c9001633
EISBN: 978-1-62708-221-1
..., wheel, tire, and steering arm of an axle assemblage that is in good working order. Fig. 1 General view of two crane wheel sets and one failed axle (middle) with wheel and wheel hub removed. The wheels are turned at different angles. Fig. 2 View of a nonfailed axle, wheel hub...
Series: ASM Failure Analysis Case Histories
Publisher: ASM International
Published: 01 June 2019
DOI: 10.31399/asm.fach.auto.c9001156
EISBN: 978-1-62708-218-1
... under low and high engine revving in neutral gear. It was found that in the left full lock position the damper cannot over-extend to give an impact blow since a wheel stop is encountered by the steering arm 10 mm before the damper's piston becomes fully extended. The fracture surface of the ferrule...
Series: ASM Failure Analysis Case Histories
Publisher: ASM International
Published: 01 June 2019
DOI: 10.31399/asm.fach.aero.c9001504
EISBN: 978-1-62708-217-4
... on the trunnion where an assembly arm, linking the end of the steering actuator and the upper torque arm, fitted. The fracture mechanics analysis of the failure showed that the fatigue crack size was critical for normal operating condition loads and that the trunnion area was underdesigned to carry the actuator...
Series: ASM Handbook Archive
Volume: 11
Publisher: ASM International
Published: 01 January 2002
DOI: 10.31399/asm.hb.v11.a0003502
EISBN: 978-1-62708-180-1
... with a kingpin mounted near vertically through the eye at each end of the axle. The yoke of each front wheel stub axle fits over the corresponding eye of the beam axle and around the kingpin, thereby forming the axis about which the stub axle can turn in order to steer the truck. Kingpins are normally simple...
Series: ASM Handbook
Volume: 11A
Publisher: ASM International
Published: 30 August 2021
DOI: 10.31399/asm.hb.v11A.a0006815
EISBN: 978-1-62708-329-4
... to facilitate the interchange of doors. Mounted on the bottom threshold was a roller that fitted into a fixed socket located within the door, forming the bottom “hinge.” At the top, the door closer unit itself acted as the hinge, mounted on the lintel overhead with a torsion arm connected to the top of the door...