Skip Nav Destination
ASM Handbook
Composites
ASM International
Volume
21
ISBN electronic:
978-1-62708-195-5
Publication date:
2001
Book Chapter
Introduction to Manufacturing of Polymer-Matrix Composites
By
B. Tomas Åström
B. Tomas Åström
IFP SICOMP AB
, Sweden
Search for other works by this author on:
-
Published:2001
Abstract
This article explains the key features of the manufacturing techniques for polymer composites. It describes the selection of a technically and economically feasible manufacturing technique for a composite design. The article discusses widely accepted and emerging techniques to manufacture polymer composites such as open-mold techniques.
You do not currently have access to this chapter.
Citation
B. Tomas Åström, Introduction to Manufacturing of Polymer-Matrix Composites, Composites, Vol 21, ASM Handbook, Edited By Daniel B. Miracle, Steven L. Donaldson, ASM International, 2001, p 421–422, https://doi.org/10.31399/asm.hb.v21.a0003401
Download citation file:
October 16-19 | Detroit, Michigan
Keep up to date with the latest materials and processing technologies. Register today for IMAT 2023 & Heat Treat 2023!
Related Book Content
Surface Degradation of Composites
Optical Microscopy of Fiber-Reinforced Composites
Wear Failures of Reinforced Polymers
Characterization and Failure Analysis of Plastics
The Effects of Lightning Strikes on Polymeric Composites
Optical Microscopy of Fiber-Reinforced Composites
Analysis of the Effects of Lightning Strikes on Polymeric Composites
Metallography and Microstructures
Open Molding: Hand Lay-Up and Spray-Up
Composites
Friction and Wear of Polymers and Polymer Composites
Friction, Lubrication, and Wear Technology
Impact Response of Composites
Metallography and Microstructures
