Skip to Main Content
Skip Nav Destination

Abstract

An alloy IN-690 (N06690) incinerator liner approximately 0.8 mm (0.031 in.) thick failed after only 250 h of service burning solid waste. Investigation supported the conclusion that the root cause of the failure was overfiring during startup and sulfidation of the nickel-base alloy. No recommendations were made.

You do not currently have access to this chapter.
Don't already have an account? Register

Failure of a Nickel-Base Alloy Incinerator Liner, ASM Failure Analysis Case Histories: Improper Maintenance, Repair, and Operating Conditions, ASM International, 2019, https://doi.org/10.31399/asm.fach.usage.c0091756

Download citation file:


Close
Close Modal

or Create an Account

Close Modal
Close Modal