Corroded Pipe Section of Oil Burner for Superheated Steam Generator
A heat exchanger made of a pipe in which oil was heated from the outside from approximately 90 deg C to 170 deg C, by superheated steam of about 8 to 10 atmospheres had developed a leak at the rolled joint of the pipe and pipe bottom. The pipes were supposed to be made from St 35.29 steel and annealed at the rolled joint to 100 mm length. The outer pipe surface was strongly pitted by corrosion all around the rolled joint. In the vicinity of the steam chamber the pipe wall had oxidized through from the exterior to the interior at one spot. Adjoining this spot, grooves caused by erosion were noticeable. This was a typical case of crevice corrosion. The rolled joint evidently was not entirely tight, so that saturated steam condensate could penetrate into the gap.
Friedrich Karl Naumann, Ferdinand Spies, 2019. "Corroded Pipe Section of Oil Burner for Superheated Steam Generator", ASM Failure Analysis Case Histories: Failure Modes and Mechanisms
Download citation file: