In this study, a possibility of application of advanced 9%Cr steel containing 130 ppm boron for boiler components utilized at around 650 °C to higher temperature steam turbine rotor materials has been investigated by means of reduction in silicon promoting macro-segregation in the case of large size ingots, using laboratory heats. Tempered martensitic microstructure without proeutectoid ferrite in all steels studied is obtained even at the center position of a turbine rotor having a barrel diameter of 1.2 m despite lower amounts of nitrogen and silicon. The strength at room temperature is almost the same level of practical high Cr steels such as X13CrMoCoVNbNB 9-2-1 for ultrasuper critical steam turbine rotors. The toughness is sufficient for high temperature rotors in comparison with CrMoV steels utilized as sub-critical high pressure steam turbine components. The creep rupture strength of the steels is higher than that of the conventional 9-12Cr steels used at about 630 °C. The creep rupture strength of 9%Cr steel containing 130 ppm B, 95 ppm N, 0.07 % Si and 0.05 % Mn is the highest in the steels examined, and it is therefore a candidate steel for high temperature turbine rotors utilized at more than 630 °C. Co-precipitation of M 23 C 6 carbides and Laves phase is observed around the prior austenite grain boundaries after the heat treatments and the restraint of the carbide growth is also observed during creep exposure. An improvement in creep strength of the steels is presumed to have the relevance to the stabilization of the martensitic lath microstructure in the vicinity of those boundaries by such precipitates.

Monoblock low-pressure (LP) turbine rotor shaft forgings for nuclear power plants have been produced from up to 600 ton ingots. However, ingots greater than 600 tons are necessary to increase the generator capacity. Segregation, non-metallic inclusions, and micro porosities inevitably increase with the increase in ingot size. Manufacturing such massive ingots with high soundness is quite difficult. Thus, the development of 650 ton ingot production was carried out in 2010. The 650 ton ingot was dissected and investigated to verify its internal quality. The internal quality of the 650 ton ingot was found to be equal to that of 600 ton ingots. Subsequently, in 2011, we produced a 670 ton ingot, the world’s largest, to produce a trial LP rotor shaft forging with a diameter of 3,200 mm. Results show that the internal quality, mechanical properties, and heat stability are the same as LP rotor shaft forgings made from 600 ton ingots.

Steels with 9-12% chromium content are widely used in steam turbines operating above 550°C due to their improved creep properties. Saarschmiede has extensive experience manufacturing high chromium steels, such as the X12CrMoWVNbN10-11-1 steel designed through the European COST program for application up to 610°C (COST Rotor E). From this steel, Saarschmiede produces high-pressure rotor shafts and gas turbine discs. To meet ever-increasing steam temperatures, a modified steel type with elevated boron content was developed, and pilot rotors have been manufactured. For ingot manufacturing of high chromium steels, Saarschmiede utilizes the Electro-Slag-Remelting process, allowing ingots up to 165 tons. Optimized forging and heat treatment procedures ensure reproducible forging properties. All products undergo rigorous destructive and non-destructive testing.