Abstract
The reasonable procedures for estimation of 100,000 h creep rupture strength have been investigated for Alloy 617 and Alloy 740 for A-USC power plants by Larson Miller method. The creep rupture data of longer duration than 500 h in the temperature range between 593 and 816 °C and between 600 and 850 °C were used for the analysis on Alloy 617 and Alloy 740, respectively. The data were obtained by Special Metals. In these temperature ranges, Ni3Al-γ’ can precipitate in Alloy 617 and Alloy 740 during creep. The maximum time to rupture was 40,126.7 and 24,066 h for Alloy 617 and Alloy 740, respectively. The rupture data for Alloy 617 exhibit large scattering, especially at 760 °C, showing a split into two groups. After eliminating the shorter time to rupture data at 760 °C, the regression analysis using the second order equation of Larson-Miller parameter gives us the Larson-Miller constant C of 12.70 and the 100,000 h creep rupture strength of 100 MPa at 700 °C. The regression analysis underestimates the constant C and corresponding 100,000 h creep rupture strength of Alloy 617, as shown by the regression curves locating below the rupture data at long times, while those locating above the rupture data at short times. The underestimation of constant C is caused by large data scattering. The linear extrapolation of log tr versus reciprocal temperature 1/T plot to 1/T = 0 at constant stresses gives us the constant C of 18.5, which is much larger than that by the regression analysis. Using an appropriate constant C of 18.45, the 100,000 h creep rupture strength of Alloy 617 is estimated to be 123 MPa at 700 °C. On the other hand, the rupture data for Alloy 740 exhibit only a little bit scattering. The regression analysis gives us C = 18.45, which agrees very well with that by the linear extrapolation of log tr versus 1/T plot to 1/T = 0. The 100,000 h creep rupture strength of Alloy 740 is estimated to be 214 and 109 MPa at 700 and 760 °C, respectively.
