Creep of the Novel Austenitic Heat Resistant Steel of Fe-20Cr-30Ni-2Nb under Steam Atmosphere at 1073 K

In this study, we have examined the creep of a novel austenitic heat resistant steel of Fe-20Cr- 30Ni-2Nb (at.%) steel at 1073K in steam and air atmospheres. Our studied steels were Fe-20Cr- 30Ni-2Nb (base steel) and that with 0.03 at. %B (B-doped steel) . The addition of boron is to intentionally increase the area fraction of Laves phase on grain boundaries (ρ). The specimen with ρ = 43% (base steel pre-aged at 1073 K/240 h) exhibits the rupture life of 262 h, whereas the rupture life of the specimen with higher ρ of 80% (B-doped steel pre-aged at 1073 K/240 h) is 833h, which is about three times longer than that of the specimen with ρ = 43%. The specimen with ρ = 80% exhibits smaller creep rate than those with lower ρ than 43% in the entire creep stage. In addition, all specimens show the creep rupture strain of about 60%. The creep rupture life is almost same to that tested under air, whereas the creep rupture strain is slightly smaller (a few percent) than that under air. In the surface of the creep ruptured specimen in steam, the intergranular oxides associated with voids or cavities are often present and grow along grain boundaries to over 100 μm in depth. The intergranular oxidation occurs more extensively in steam rather than air. These results demonstrate that stable Fe₂Nb Laves phase on grain boundary could increase the creep resistance of the present steel at 1073K without ductility loss in steam as well as air, resulting in the pronounced extension of rupture life. The intergranular oxidation accelerated by steam would not give a serious effect on the creep properties of the present steel below 103 hours in rupture life.