1-7 of 7 Search Results for

Orbit

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Alloy Digest (1963) 12 (3): TS-131.
Published: 01 March 1963
... Orbit is a free-machining, low-alloy, air-hardening tool steel providing maximum dimensional stability. This datasheet provides information on composition, physical properties, hardness, and elasticity as well as fracture toughness. It also includes information on forming, heat treating, machining...
Journal Articles
Alloy Digest (2001) 50 (1): SS-813.
Published: 01 January 2001
... alloy, especially in the welded condi- tion. Earlier duplex alloys had moderate resistance to general corrosion and chloride SCC but suffered a substantial loss of mechanical properties when used in the as-welded condition. Table 3 Maximum Coil Lengths Maximum coil length, ft Size, in. Without orbital...
Journal Articles
Alloy Digest (1991) 40 (11): Cer-7.
Published: 01 November 1991
.... When machining or abrading edges always work parallel to the layer planes avoiding cross- grain or orbital motion. In sawing, use a fine toothed blade, cutting part way through one plane then turning the work and sawing through the opposite plane surface. For cutting to finished size or smooth edge...
Journal Articles
Alloy Digest (2005) 54 (9): SS-938.
Published: 01 September 2005
... results in a virtually unde- tectable longitudinal weld and a tube with a more uniform wall thickness, which allows higher quality orbital welds in the field. Manufacturing includes a proprietary tungsten inert gas (TIG) method of welding. The weld bead is then cold worked to a full finished condition...
Journal Articles
Alloy Digest (2001) 50 (1): SA-507.
Published: 01 January 2001
... with auto- matic orbital tungsten inert gas (TIG) equipment. Filler metal was a wire with nearly the same chemical composition as the base material (same heat). Face bend and root bend tests were performed according to ASME Code Section IX on 12.7 mm (0.5 in.) wide specimens with machined faces...
Journal Articles
Alloy Digest (2005) 54 (4): TS-616.
Published: 01 April 2005
.... Applications and tools of special interest include warm forging dies and punches, roll forging, rolling segments, rock orbital forging, punches, and dies, upset forging, clamping tools, progressive forging, dies, axial closed die rolling, top and bottom dies, cross forming segments, hot bending tools, hot...
Journal Articles
Alloy Digest (2002) 51 (1): SS-841.
Published: 01 January 2002
... tubing contain strip splice, longitudinal seam, and orbital welds. The coils are manufactured in accordance with ASTM A 789. The microstructural characterization consists of an assessment of the ferrite content. The mechanical properties assessment consists of tensile, hard- ness, and burst testing...